Frelander 2. Manual — part 668
5. Tack weld the butt joint.
6. Spot weld.
7. Dress the tack welds.
8. MIG weld the butt joint.
9. Dress all welded joints.
10. The installation of associated panels and mechanical
components is the reverse of removal.
Rear End Sheet Metal Repairs - Rear Wheelhouse Front Extension
Removal and Installation
Removal
• NOTE: The rear wheelhouse front extension is to be unpicked from the rear wheelhouse outer service panel.
1. The rear wheelhouse front extension is replaced in conjunction
with:
Rear bumper cover
Quarter panel
Rear door
Quarter glass
Inner quarter panel
2. For additional information relating to this repair procedure
please see the following:
For additional information, refer to:
Body and Frame
(501-26
Body Repairs - Vehicle Specific Information and Tolerance
Checks, Description and Operation) /
Standard Workshop Practices
(100-00 General Information,
Description and Operation).
3. Remove the inner quarter panel.
For additional information, refer to:
Inner Quarter Panel
(501-30 Rear End Sheet Metal Repairs, Removal and
Installation).
4. Mill out the spot welds.
5. Separate the joints and remove the old panel.
Installation
1. Remove the rear wheelhouse front extension from the
wheelhouse outer service panel.
2. Prepare the old and new panel joint surfaces.
3. Drill holes in the new panel ready for MIG plug welding.
4. Offer up the new panel and clamp into position. Check
alignment, if correct, proceed to next step, if not, rectify and
recheck before proceeding.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст