Frelander 2. Manual — part 485
Exterior Lighting - Front Fog Lamp LH
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Torque: 2.5 Nm
1.
2. NOTE: Do not disassemble further if the component
is removed for access only.
2.
Installation
To install, reverse the removal procedure.
1.
Check the fog lamp beam alignment.
Refer to:
Front Fog Lamp Adjustment
(417-01 Exterior Lighting,
General Procedures).
2.
Exterior Lighting - Headlamp Assembly
Removal and Installation
Removal
WARNING: Vehicles fitted with Xenon headlamps, the following precautions must be observed. Failure to comply may
result in exposure to ultra violet rays, severe electric shock, burns or the risk of explosion. Ensure the headlamps are
switched off at all times. Eye and hand protection must be worn. Never switch on the lamps or test the bulbs with the
lamp holder released from the headlamp.
• NOTE: Removal steps in this procedure may contain installation details.
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Torque: 4 Nm
2.
3. NOTE: Do not disassemble further if the component is removed
for access only.
3.
4.
5.
6.
7.
8.
9.
Installation
To install, reverse the removal procedure.
1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст