Frelander 2. Manual — part 175
Engine - I6 3.2L Petrol - Engine Upper Support Insulator
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Torque: 10 Nm
1.
Torque: 110 Nm
2.
Installation
To install, reverse the removal procedure.
1.
Engine - I6 3.2L Petrol - Engine Lower Support Insulator
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the engine undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
2.
3.
CAUTION: Make sure that these components
are installed to the noted removal position.
Remove the lower support insulator.
Torque: 110 Nm
3.
Vehicles with petrol engine
4. NOTE: Do not disassemble further if the component
is removed for access only.
Remove the heat shield.
Torque: 10 Nm
4.
All vehicles
Remove the engine mount link brackets.
Torque: 110 Nm
5.
Installation
To install, reverse the removal procedure.
1.
Engine - I6 3.2L Petrol - Engine Mount LH
Removal and Installation
General Equipment
Transmission jack
Removal
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the engine undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
2.
Support the transmission.
General Equipment:
Transmission jack
3.
Remove the air cleaner assembly.
Refer to:
Air Cleaner
(303-12A Intake Air Distribution and Filtering -
I6 3.2L Petrol, Removal and Installation).
4.
Remove the battery tray.
Refer to:
Battery Tray
(414-01 Battery, Mounting and Cables,
Removal and Installation).
5.
6.
WARNING: Make sure that new nuts are
installed.
• NOTE: Vehicles with automatic transmission have a
breather pipe attached to the mounting.
Remove the bracket.
Torque:
M12 80 Nm
M8 25 Nm
6.
Remove the engine mount LH.
Torque: 175 Nm
7.
Installation
To install, reverse the removal procedure.
1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст