Frelander 2. Manual — part 176
Engine - I6 3.2L Petrol - Engine Mount RH
Removal and Installation
Special Tool(s)
303-1254
Support, Engine
Removal
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the engine undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
2.
Remove the RH front wheel and tire.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
3.
Remove the fender splash shield extension panel.
4.
Support the engine.
Special Tool(s):
303-1254
5.
Remove the engine cover.
Refer to:
Engine Cover - I6 3.2L Petrol
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
6.
Remove the stabilizer bar.
Refer to:
Engine Upper Support Insulator
(303-01A Engine - I6 3.2L
Petrol, Removal and Installation).
7.
Torque:
M10 45 Nm
M12 80 Nm
8.
Torque: 80 Nm
9.
Installation
To install, reverse the removal procedure.
1.
Engine - I6 3.2L Petrol - Timing Cover
Removal and Installation
Special Tool(s)
303-1227
Installer, Auxiliary Drive Seal
303-1228
Holder, Generator Pulley
Removal
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the cover and disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
2.
Drain the coolant.
Refer to:
Cooling System Draining, Filling and Bleeding
(303-03A
Engine Cooling - I6 3.2L Petrol, General Procedures).
3.
Remove the accessory drive pulley.
Refer to:
Accessory Drive Pulley
(303-05A Accessory Drive - I6 3.2L
Petrol, Removal and Installation).
4.
5.
CAUTION: The O-ring seal is to be reused
unless damaged.
Remove the brake vacuum pump.
5.
Remove the power steering pump support bracket.
6.
Release the power steering pump and tie aside
7.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст