Frelander 2. Manual — part 358
Manual Transmission/Transaxle - Transmission Draining and Filling
General Procedures
WARNING: Observe due care when draining, as the fluid can be very hot.
1.
WARNING: Do not work on or under a vehicle supported only
by a jack. Always support the vehicle on safety stands.
• NOTE: Make sure that the vehicle is standing on a level surface.
Raise and support the vehicle.
1.
Remove the front undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
2.
Clean the area around the transmission fluid level/filler plug.
3.
Remove the transmission fluid filler/level plug.
4.
Clean the area around the transmission fluid drain plug.
5.
Place a container under the transmission.
6.
Remove the transmission fluid drain plug.
7.
8.
CAUTION: Replace the washer.
Install the transmission fluid drain plug.
Torque: 30 Nm
8.
Fill the transmission with the correct fluid until it runs from the
level/filler plug.
9.
10.
CAUTION: Replace the washer.
Install the transmission fluid filler/level plug.
Torque: 35 Nm
10.
Install the front undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
11.
Manual Transmission/Transaxle - Transmission Fluid Level Check
General Procedures
WARNING: Observe due care when draining, as the fluid can be very hot.
1.
WARNING: Do not work on or under a vehicle supported only
by a jack. Always support the vehicle on safety stands.
• NOTE: Make sure that the vehicle is standing on a level surface.
Raise and support the vehicle.
1.
Remove the front undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
2.
Clean the area around the transmission fluid level/filler plug.
3.
Remove the transmission fluid filler/level plug.
4.
Fill the transmission with the correct fluid until it runs from the
level/filler plug.
5.
6.
CAUTION: Replace the washer.
Install the transmission fluid filler/level plug.
Torque: 35 Nm
6.
Install the front undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
7.
Manual Transmission/Transaxle - Halfshaft Seal RH
Removal and Installation
Special Tool(s)
303-1300
Remover, Crankshaft Seal
303-882
Installer, Halfshaft Seal
Removal
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the RH halfshaft.
Refer to:
Front Halfshaft RH
(205-04 Front Drive Halfshafts, Removal
and Installation).
2.
3. CAUTIONS:
Make sure that the area around the component is
clean and free of foreign material.
Take extra care not to damage the mating faces.
Special Tool(s):
303-1300
3.
Installation
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст