Frelander 2. Manual — part 625
Supplemental Restraint System - Clockspring
Removal and Installation
Removal
Make the SRS system safe.
Refer to:
Standard W orkshop Practices
(100-00 General Information,
Description and Operation).
1.
2.
CAUTION: Make sure that the road wheels are in the
straight ahead position.
Remove the steering wheel.
Refer to:
Steering Wheel
(211-04 Steering Column, Removal and
Installation).
2.
Release the steering column adjustment lever.
3.
Remove the steering column upper cowl.
4.
Remove the steering column lower cowl.
5.
6.
CAUTION: Make sure that the clockspring rotor
does not rotate.
Remove the clockspring.
6.
Installation
1.
CAUTION: Correct clockspring alignment can be found by
viewing a yellow marker through the window situated on the
clockspring face, at the 8 o'clock position. If the marker is not
visible, carefully turn the clockspring fully clockwise. Turn the
clockspring in a counterclockwise direction 3.25 turns. The yellow
marker should now be in the central position.
To install, reverse the removal procedure.
1.
Supplemental Restraint System - Occupant Classification Sensor
Removal and Installation
Removal
• NOTE: The occupant classification sensor is part of the passenger seat cushion. The sensor is only fitted to NAS models.
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Remove the front seat cushion cover.
Refer to:
Front Seat Cushion Cover
(501-10 Seating, Removal and
Installation).
2.
Installation
Install the front seat cushion cover.
Refer to:
Front Seat Cushion Cover
(501-10 Seating, Removal and
Installation).
1.
Connect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
2.
Using IDS, configure a new occupant classification sensor.
3.
Supplemental Restraint System - B-Pillar Side Impact Sensor
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Make the SRS system safe.
Refer to:
Standard W orkshop Practices
(100-00 General Information,
Description and Operation).
2.
Remove the front scuff plate trim panel.
Refer to:
Front Scuff Plate Trim Panel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
3.
Torque: 10 Nm
4.
Installation
To install, reverse the removal procedure.
1.
Supplemental Restraint System - C-Pillar Side Impact Sensor
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Make the SRS system safe.
Refer to:
Standard W orkshop Practices
(100-00 General Information,
Description and Operation).
2.
Remove the rear quarter trim panel.
Refer to:
Rear Quarter Trim Panel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
3.
Torque: 10 Nm
4.
Installation
To install, reverse the removal procedure.
1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст