Frelander 2. Manual — part 181
Engine - I6 3.2L Petrol - Crankshaft Main Bearing Carrier
Removal and Installation
Special Tool(s)
303-1219
Locking Tool, Crankshaft
303-1278
Aligner, Timing Cover
303-1280
Remover, Oil Pump Pin
303-1284
Torx Socket, Accessory Drive Pulley
Removal
• NOTE: Removal steps in this procedure may contain installation details.
• NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
1.
WARNING: Do not work on or under a vehicle supported only by a jack.
Always support the vehicle on safety stands.
Raise and support the vehicle.
1.
2.
WARNING: Avoid skin contact with the specified material.
• CAUTIONS:
Hot fluid.
Be prepared to collect escaping fluids.
Torque: 38 Nm
Remove and discard the sealing washer.
2.
Refer to:
Engine
(303-01A Engine - I6 3.2L Petrol, Removal).
3.
4.
Special Tool(s):
303-1284
,
303-1278
Torque: 60 Nm
5.
Torque: 65 Nm
6.
7. NOTE: This step requires the aid of another technician.
Torque: 65 Nm
7.
8. NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
If the locking pin on the special tool is disengaged, the
crankshaft can be rotated.
Special T ool(s):
303-1219
8.
Torque: 10 Nm
9.
Torque: 47 Nm
10.
Torque: 10 Nm
11.
12.
CAUTION: Make sure that the torque converter remains in the
transmission.
• NOTE: This step requires the aid of another technician.
Torque: 47 Nm
12.
Mount the engine to an engine stand.
13.
Torque: 10 Nm
14.
Torque: 10 Nm
15.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст