Frelander 2. Manual — part 219
Engine - TD4 2.2L Diesel - Oil Filter Element
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Do not work on or under a vehicle supported only
by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
1.
Remove the engine undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
2.
3.
WARNING: Fluid loss is unavoidable, use
absorbent cloth or a container to collect the fluid.
• CAUTIONS:
Make sure that the area around the component is
clean and free of foreign material.
Discard the seal.
Torque: 25 Nm
3.
Installation
To install, reverse the removal procedure.
1.
Check and top-up the engine oil.
2.
Engine - TD4 2.2L Diesel - Engine Mount LH
Removal and Installation
General Equipment
Transmission jack
Removal
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the engine undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
2.
Support the transmission.
General Equipment:
Transmission jack
3.
Remove the air cleaner assembly.
Refer to:
Air Cleaner
(303-12A Intake Air Distribution and Filtering -
I6 3.2L Petrol, Removal and Installation).
4.
Remove the battery tray.
Refer to:
Battery Tray
(414-01 Battery, Mounting and Cables,
Removal and Installation).
5.
6.
WARNING: Make sure that new nuts are
installed.
• NOTE: Vehicles with automatic transmission have a
breather pipe attached to the mounting.
Remove the bracket.
Torque:
M12 80 Nm
M8 25 Nm
6.
Remove the engine mount LH.
Torque: 175 Nm
7.
Installation
To install, reverse the removal procedure.
1.
Engine - TD4 2.2L Diesel - Engine Mount RH
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the engine undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
2.
Support the engine.
3.
Remove the engine cover.
Refer to:
Engine Cover - TD4 2.2L Diesel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
4.
Remove the engine upper support insulator.
Refer to:
Engine Upper Support Insulator
(303-01A Engine - I6 3.2L
Petrol, Removal and Installation).
5.
Torque:
M14 175 Nm
M12 80 Nm
6.
Torque: 80 Nm
7.
Installation
To install, reverse the removal procedure.
1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст