Defender. Manual — part 152
Electronic Engine Controls - 2.4L Duratorq-TDCi HPCR (103kW/140PS) -
Puma - Cylinder Head Temperature (CHT) Sensor
Removal and Installation
Special Tool(s)
Socket, CHT Sensor
303-680
Removal
1. Remove the engine cover.
For additional information, refer to:
Engine Cover
(501-05
Interior Trim and Ornamentation, Removal and Installation).
2. Disconnect the cylinder head temperature (CHT) sensor.
3. Release the CHT sensor wiring harness.
4. Using the special tool, remove the CHT sensor.
Installation
1. To install, reverse the removal procedure.
Tighten to 10 Nm (7 lb.ft).
Electronic Engine Controls - 2.4L Duratorq-TDCi HPCR (103kW/140PS) -
Puma - Engine Control Module (ECM)
Removal and Installation
Removal
CAUTION: When a new engine control module (ECM) is installed, the Land Rover approved diagnostic system must
be connected to the vehicle and the ECM renewal procedure must be followed. This will allow the vehicle configuration
to be uploaded into the new ECM.
1. Disconnect the battery ground cable.
For additional information, refer to:
Battery Disconnect and
Connect
(414-01 Battery, Mounting and Cables, General
Procedures).
2. Remove the engine control module (ECM) security bracket.
Remove the bolt.
3. Disconnect the 3 electrical connectors.
4. Remove the 2 ECM nuts.
5. Remove the ECM.
5. Remove the ECM.
Installation
1. To install, reverse the removal procedure.
Tighten to 10 Nm (7 lb.ft).
2.
CAUTION: Make sure that the fuel pump replacement
and pilot correction learn are carried out following the
download.
Using the Land Rover approved diagnostic system, configure
the new ECM.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст