Defender. Manual — part 268
7. To remove barrel from plastic retaining sleeve, depress
spring loaded button and withdraw sleeve.
Installation
• NOTE: If a new barrel is being installed, check that number on barrel coincides with number on accompanying key.
1. Push plastic retaining sleeve over barrel until spring loaded
peg locks it into position.
2. Install barrel and plastic sleeve assembly to locking sleeve
and insert into exterior handle reversing instruction 6.
3. Assemble lock lever components as illustrated and from
inside of door panel, install them to barrel assembly with
single screw.
4. Connect operating rod to lock lever and secure with spring
clip, reversing instruction 4.
5. Install front door reinforcement panel.
For additional information, refer to:
Front Door Reinforcement
Panel
(501-03 Body Closures, Removal and Installation).
6. Install plastic sheet.
7. Install door trim panel.
For additional information, refer to:
Front Door Trim Panel
(501-05 Interior Trim and Ornamentation, Removal and
Installation).
Handles, Locks, Latches and Entry Systems - Exterior Front Door Handle
Removal and Installation
Removal
1. Remove door trim panel.
For additional information, refer to:
Front Door Trim Panel
(501-05 Interior Trim and Ornamentation, Removal and
Installation).
2. Remove door reinforcement panel and support glass with
timber.
For additional information, refer to:
Front Door Reinforcement
Panel
(501-03 Body Closures, Removal and Installation).
3. Disconnect operating rod from handle mechanism.
4. Disconnect rod from locking barrel lever.
5. Remove 2 screws and withdraw handle assembly.
Installation
1. Install handle to door ensuring that two bezels are in
position - flat faces towards door, and secure with 2 screws.
2. Connect rod to handle operating lever and secure with spring
clip.
3. Connect rod to locking barrel lever and retain with spring
clip.
4. Install door reinforcement panel.
For additional information, refer to:
Front Door Reinforcement
Panel
(501-03 Body Closures, Removal and Installation).
Handles, Locks, Latches and Entry Systems - Exterior Rear Door Handle
Removal and Installation
Removal
1. Remove door trim panel.
For additional information, refer to:
Rear Door Trim Panel
(501-05 Interior Trim and Ornamentation, Removal and
Installation).
2. Peel back sufficient of plastic sheet to gain access to handle
mechanism.
3. Disconnect actuating rod from handle operating lever.
4. Remove 2 screws and withdraw handle and bezels.
Installation
1. Install handle to door ensuring that both bezels are in
position - flat faces towards door and secure with 2 screws.
2. Connect actuating rod to handle operating lever and secure
with spring clip.
3. Re-seal plastic sheet.
4. Install door trim panel.
For additional information, refer to:
Rear Door Trim Panel
(501-05 Interior Trim and Ornamentation, Removal and
Installation).
Handles, Locks, Latches and Entry Systems - Interior Rear Door Handle
Removal and Installation
Removal
1. Remove door trim panel.
For additional information, refer to:
Rear Door Trim Panel
(501-05 Interior Trim and Ornamentation, Removal and
Installation).
2. Peel-back sufficient of plastic sheet to gain access to remote
lever.
3. Remove spring clip and disconnect control rod from push
button.
4. Release spring clip and disconnect short locking button
control rod from latch mechanism.
5. Disconnect long remote control rod from latch assembly.
6. Remove 2 screws securing remote control lever to mounting
panel.
7. Release control rods from plastic retaining clips located in
mounting panel.
8. Withdraw remote control lever and rods from door.
Installation
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст