Defender. Manual — part 267
Handles, Locks, Latches and Entry Systems - Front Door Latch
Removal and Installation
Removal
1. Remove door reinforcing panel and support glass with
timber.
For additional information, refer to:
Front Door Reinforcement
Panel
(501-03 Body Closures, Removal and Installation).
2. Disconnect control rod from handle operating lever.
3. Disconnect control rod from locking lever on handle.
4. Disconnect push button control rod and linkage from latch
mechanism.
5. Remove 2 screws and remove handle assembly from door.
6. Remove 2 self-tapping screws retaining lower end of
window glass runner.
7. Remove 3 screws securing latch assembly to door.
7. Remove 3 screws securing latch assembly to door.
8. Whilst taking care not to damage runner, ease runner away
from latch and manoeuvre latch assembly from door.
Installation
1. Carefully ease window runner away, sufficiently to enable
latch to be located into position.
2. Secure latch to door with 3 screws.
3. Secure window runner with 2 screws ensuring that packing
strip is in position and that screw heads are below bottom of
runner to prevent damage to glass.
4. Install handle with 2 screws, ensuring that bezels are in
position.
5. Connect control rod to handle operating lever and secure
with spring clip.
6. Connect control rod to locking lever and retain with spring
clip.
7. Connect push button control rod and linkage to latch lever
and secure with spring clip.
8. Install mounting panel.
For additional information, refer to:
Front Door Reinforcement
Panel
(501-03 Body Closures, Removal and Installation).
Handles, Locks, Latches and Entry Systems - Rear Door Latch
Removal and Installation
Removal
1. Remove door trim panel.
For additional information, refer to:
Rear Door Trim Panel
(501-05 Interior Trim and Ornamentation, Removal and
Installation).
2. Peel-back sufficient of plastic sheet to reveal latch.
3. Release remote control lever rod from latch assembly.
4. Disconnect door outer handle control rod from latch
assembly.
5. Disconnect door locking button remote control rod from latch
mechanism.
6. Remove 3 retaining screws and withdraw latch assembly
from door.
Installation
1. Install latch assembly to door and secure with 3 screws,
noting that uppermost screw is longer.
2. Connect remote control levers to latch mechanism reversing
instructions 3, 4 and 5.
3. Re-seal plastic sheet and install door trim panel.
For additional information, refer to:
Rear Door Trim Panel
(501-05 Interior Trim and Ornamentation, Removal and
Installation).
Handles, Locks, Latches and Entry Systems - Door Lock Cylinder
Removal and Installation
Removal
1. Remove door trim panel and plastic sheet.
For additional information, refer to:
Front Door Trim Panel
(501-05 Interior Trim and Ornamentation, Removal and
Installation).
2. Remove reinforcement panel.
For additional information, refer to:
Front Door Reinforcement
Panel
(501-03 Body Closures, Removal and Installation).
3. Raise and support glass to gain access to latch mechanism.
4. Release spring clip and disconnect rod from lock operating
lever.
5. Remove single screw and withdraw lock lever assembly.
6. Withdraw lock barrel from exterior door handle complete
with locking sleeve.
7. To remove barrel from plastic retaining sleeve, depress
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст