Defender. Manual — part 210
11. Remove the center register duct.
12. Remove the air inlet duct.
Remove the nut.
13. Disconnect the defrost duct blend door control cable.
Release the clip.
14. Disconnect the footwell duct blend door control cable.
Release the clip.
15. Release the grommet from the bulkhead.
15. Release the grommet from the bulkhead.
16. Remove the heater core housing.
Remove the 4 nuts.
Installation
1. To install, reverse the removal procedure.
Tighten to 15 Nm (11 lb.ft).
2. Connect the battery ground cable.
For additional information, refer to:
Battery Connect
(414-01
Battery, Mounting and Cables, General Procedures).
Air Conditioning - 2.4L Duratorq-TDCi HPCR (103kW/140PS) - Puma -
Lubricant
Item
Specification
Compressor oil
SP-15
Lubricant
Item
Specification
Compressor oil
SP-15
Total system capacity
600g +/- 25g
Compressor
4.56 FL. OZ
System Refrigerant Specification/Capacity
Item
Specification
Refrigerant type
R134A
Total system capacity
600g +/- 25g
General Specification
Item
Description
Compressor:
Make
Sandan
Type
SD7H15
Torque Specifications
Description
Nm
lb-ft
A/C compressor bolts
48
35
A/C compressor low-pressure and high-pressure pipe bolt
30
22
A/C condenser core low-pressure and high-pressure refrigerant lines
8
6
Condenser core and condenser fan assembly bolts
15
11
Condenser fan bolts
2
1
Condenser core nuts
8
6
A/C receiver drier nuts
8
6
A/C receiver drier low-pressure and high-pressure refrigerant line bolts
8
6
Power steering fluid reservoir nuts
4
3
Air Conditioning - 2.4L Duratorq-TDCi HPCR (103kW/140PS) - Puma - Air
Conditioning (A/C) Compressor
Removal and Installation
Removal
1. Disconnect the battery ground cable.
For additional information, refer to:
Battery Disconnect and
Connect
(414-01 Battery, Mounting and Cables, General
Procedures).
2. Recover the air conditioning (A/C) refrigerant.
For additional information, refer to:
Air Conditioning (A/C)
System Recovery, Evacuation and Charging
(412-00 Climate
Control System - General Information, General Procedures).
3.
CAUTION: Make sure that all openings are sealed. Use
new blanking caps.
Disconnect the A/C compressor low-pressure and high-
pressure refrigerant lines.
Remove the bolt.
Remove and discard the O-ring seal.
4. Remove the accessory drive belt.
For additional information, refer to:
Accessory Drive Belt
(303-05 Accessory Drive - 2.4L Duratorq-TDCi HPCR
(103kW/140PS) - Puma, Removal and Installation).
5. Disconnect the compressor clutch electrical connector.
6. Remove the A/C compressor.
Remove the 3 bolts.
Installation
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст