Defender. Manual — part 211
1. NOTE: If a new compressor is being installed, the required
amount of refrigerant oil must be drained from it.
To install, reverse the removal procedure.
Tighten to 23 Nm (17 lb.ft).
2. NOTE: Coat the compressor O-ring seals in clean
refrigerant oil prior to installation.
• NOTE: Remove and discard the blanking caps.
Tighten to 30 Nm (22 lb.ft).
Install new O-ring seals.
3. Connect the battery ground cable.
For additional information, refer to:
Battery Connect
(414-01
Battery, Mounting and Cables, General Procedures).
Air Conditioning - 2.4L Duratorq-TDCi HPCR (103kW/140PS) - Puma - Air
Conditioning (A/C) Switch
Removal and Installation
Removal
1. Disconnect the battery ground cable.
For additional information, refer to:
Battery Disconnect and
Connect
(414-01 Battery, Mounting and Cables, General
Procedures).
2. Remove the audio unit.
For additional information, refer to:
Audio Unit
(415-01A
Audio Unit, Removal and Installation).
3. Release the instrument panel console.
4. Release the air conditioning (A/C) switch.
5. Remove the A/C switch.
Disconnect the electrical connector.
Installation
1. To install, reverse the removal procedure.
2. Connect the battery ground cable.
For additional information, refer to:
Battery Connect
(414-01
Battery, Mounting and Cables, General Procedures).
Air Conditioning - 2.4L Duratorq-TDCi HPCR (103kW/140PS) - Puma -
Condenser Core
Removal and Installation
Removal
1. Disconnect the battery ground cable.
For additional information, refer to:
Battery Disconnect and
Connect
(414-01 Battery, Mounting and Cables, General
Procedures).
2. Recover the air conditioning (A/C) refrigerant.
For additional information, refer to:
Air Conditioning (A/C)
System Recovery, Evacuation and Charging
(412-00 Climate
Control System - General Information, General Procedures).
3. Remove the radiator grille.
For additional information, refer to:
Radiator Grille
(501-08
Exterior Trim and Ornamentation, Removal and Installation).
4. Disconnect the condenser fan electrical connector.
5. Disconnect the A/C condenser core low-pressure and high-
pressure refrigerant lines.
Remove the 2 bolts.
Remove and discard the O-ring seals.
6. Release the condenser fan electrical connector.
7. Remove the condenser core and condenser fan assembly.
7. Remove the condenser core and condenser fan assembly.
Remove the 3 bolts.
8. Remove the condenser fan.
Remove the 4 bolts.
9. Remove the condenser core.
Remove the 8 nuts.
Installation
1. To install, reverse the removal procedure.
Tighten to 8 Nm (6 lb.ft).
2. Tighten to 2 Nm (1 lb.ft).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст