Defender. Manual — part 166

58. Remove the reversing lamp switch.

59. Remove the clutch slave cylinder.

Remove the connecting pipe securing clip.

Remove the connecting pipe.

Remove the 3 bolts.

60. Remove the gearshift yoke securing nut.

61. Using the special tool, remove the gearshift yoke.

Remove the pin.

Manual Transmission/Transaxle - Transmission

Disassembly

Special Tool(s)

Mounting Bracket, Engine/Differential

205-329

Slide Hammer

100-012

Remover Seals

308-615

Rear Seal Remover/Replacer.

303-538

Puller

308-516

Installer

205-081A

Remover Slider

308-652

Remover Selector Shaft Seal

308-621

Adaptor Slide Hammer

100-012-01

Seal Remover Input & Output

308-375

Remover, Detent

308-657

Adapter for 205-071 (Thrust Pad)

205-071-01

Installer, Mainshaft Double Lip Seal

308-150

Installer, Transmission Extension

Housing Bushing/Seal

308-044

Remover, Bearing/Gear

205-310

Installer, Differential Bearing

205-082

Remover, Countershaft Bearing Outer

Race

100-012-06

Adapter, Slide Hammer

100-012-05

Locking Tool, Output Flange

308-701

Disassembly

• NOTE: Make sure the positions of the transmission component are marked before removal.

1. Disconnect the battery ground cable.

For additional information, refer to:

Battery Disconnect and

Connect

(414-01 Battery, Mounting and Cables, General

Procedures).

2.

WARNING: Do not work on or under a vehicle

supported only by a jack. Always support the vehicle on safety

stands.

Raise and support the vehicle.

3. Drain the transmission oil.

For additional information, refer to:

Transmission Draining

and Filling

(308-03 Manual Transmission/Transaxle, General

Procedures).

4. Remove the transmission.

For additional information, refer to:

Transmission

(308-03

Manual Transmission/Transaxle, Removal).

5. Using the special tools, secure the transmission.

6. Using the special tool, lock the output shaft flange.

Remove the bolt.

7. Using the special tools, remove and discard the input shaft

seal.

8. Remove and discard the input shaft snap ring.