Defender. Manual — part 250
Interior Trim and Ornamentation - Sun Visor
Removal and Installation
Removal
1. Raise sun visor.
2. Remove 2 screws and collect sun visor.
Installation
1. Position sun visor and secure with 2 screws.
Interior Trim and Ornamentation - Taildoor Trim Panel
Removal and Installation
Removal
1. Remove the taildoor trim panel trim finisher.
2. Remove the taildoor grab handle.
Remove the 4 screws.
3. Remove the taildoor trim panel.
Release the 9 clips.
4. NOTE: Do not carry out further dismantling if component is
removed for access only.
Remove the 9 clips from the taildoor trim panel.
Installation
1. To install, reverse the removal procedure.
Tighten to 6 Nm (4 lb.ft).
Exterior Trim and Ornamentation - Exterior Rollover Bar
Removal and Installation
Removal
1. Remove Torx bolt, from both sides, securing top of rollover
bar to roof mounted bar.
2. With assistance to support rollover bar at windshield, remove
4 Torx bolts, from both sides, securing rollover bar to fender
mounting.
3. Remove two Torx bolts, from both sides, securing top bar to
roof mounting.
4. Slide top bars rearwards to disengage from main rollover bar
assembly.
5. Lift main rollover bar assembly from vehicle.
6. If necessary, remove 2 Torx bolts and nuts, from both sides,
and detach lower cross bar from main rollover bar.
Installation
1. Locate lower cross bar into main rollover bar mounting
brackets and secure with Torx bolts and nuts tightened to 25
Nm (18 lbf.ft).
2. Ensure rubber gaskets are fitted correctly to rollover bar
mounting brackets.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст