Defender. Manual — part 251
3. With assistance, lift rollover bar assembly and position on
fenders.
4. Slide top bars into main rollover bar, position on roof
mounting and secure withTorx bolts to 25 Nm (18 lbf ft.).
5. Secure rollover bar to both fender mountings with Torx
bolts. Tighten to 25 Nm (18 lbf.ft).
6. Secure top bars to main rollover bar and tighten fixing bolts
to 25 Nm (18 lbf.ft).
Exterior Trim and Ornamentation - Radiator Grille
Removal and Installation
Removal
1. Disconnect the battery ground cable.
For additional information, refer to:
Battery Disconnect and
Connect
(414-01 Battery, Mounting and Cables, General
Procedures).
2. Remove the radiator grille.
Remove the 6 screws.
Installation
1. To install, reverse the removal procedure.
2. Connect the battery ground cable.
For additional information, refer to:
Battery Connect
(414-01
Battery, Mounting and Cables, General Procedures).
Exterior Trim and Ornamentation - Rear Folding Step
Removal and Installation
Removal
1. Remove 2 bolts securing step to chassis member, remove
step and collect spacers.
Installation
1. Position step, fit spacer washers and tighten bolts.
Exterior Trim and Ornamentation - Towbar
Removal and Installation
Removal
1. Remove 4 bolts securing stabilizer bar to rear undershield.
2. Remove 6 bolts securing rear undershield to chassis.
3. Remove rear undershield.
4. Remove bolt, washer and nut from both sides, securing tow
bar lower mounting brackets and towing eyes to chassis.
5. Remove 4 bolts and spring washers securing tow bar centre
mounting bracket to chassis.
6. Remove both bolts securing 2 tow bar locating tubes in
chassis rear cross member.
7. Remove 2 bolts securing tow bar top mounting brackets to
chassis.
8. With assistance, withdraw tow bar assembly from chassis.
Installation
1. With assistance, lift tow bar assembly and locate both tubes
in chassis crossmember.
2. Secure top tow bar mounting brackets to chassis but do not
fully tighten fixings.
3. Secure tow bar locating tubes to rear of chassis and tighten
bolts to 25 Nm (18 lbf.ft).
4. Secure tow bar centre mounting bracket to underside of
chassis and tighten bolts to 25 Nm (18 lbf.ft).
5. Position towing eyes to lower mounting brackets and secure
to chassis and tighten bolts to 25 Nm (18 lbf.ft).
6. Fully tighten tow bar top mounting bracket bolts to 25 Nm
(18 lbf.ft).
7. Fit rear undershield and secure to chassis with bolts.
8. Fit bolts securing rear stabilizer bar and tighten to 30 Nm
(22 lbf.ft).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст