Range Rover Classic. Manual — part 188
86
ELECTRICAL
40
REPAIR
SUBWOOFER BOX
Service repair no - 86.50.51
Remove
1. Disconnect battery negative lead.
2. Remove rear parcel shelf RH support panel.
3. Disconnect multiplugs.
4. Remove 3 bolts securing side of subwoofer box
to body.
5. Remove 4 bolts securing bottom of subwoofer
box to body.
6. Withdraw subwoofer box, disconnect speaker
lead.
NOTE:
Do not carry out further
dismantling if component is removed for
access only.
ELECTRICAL
41
REPAIR
7. Remove 10 screws securing both halves of
subwoofer box.
8. Remove top half of box.
9. Remove speaker.
See CHASSIS AND BODY,
Repair, Parcel Shelf
Refit
10. Reverse removal procedure.
HEATED FRONT SCREEN
Heated front screen will operate when switch is
operated, with engine running. Timer unit will provide
a preset time cycle of 7 1/2 minutes
±
20%.
To identify timer unit.
Switching OFF ignition, or further operation of heated
front screen switch during cycle will switch off screen
and cancel, reset and switch off timer unit.
86
ELECTRICAL
42
REPAIR
RADIO
Service repair no - 86.50.03
Remove
1. Disconnect battery negative lead.
2. Remove access covers from radio.
3. Insert suitable radio removal tools e.g. SMD
4091 into access holes.
4. Press removal tools to release radio.
5. Remove radio, disconnect radio aerial, CD aerial
and multiplugs from rear of radio.
Refit
6. Reverse removal procedure.
7. Reactivate radio code.
COOLANT TEMPERATURE TRANSMITTER - V8i
Service repair no - 26.10.02
Remove
1. Disconnect battery negative lead.
2. Disconnect lead from transmitter.
3. Remove transmitter, discard sealing washer if
fitted.
Refit
4. Coat threads of replacement transmitter with
Loctite 572.
5. Fit a new sealing washer to transmitter.
6. Fit transmitter, connect lead.
7. Top-up cooling system.
ELECTRICAL
43
REPAIR
CLOCK AND BULB
Service repair no - 88.15.07 - Clock
Service repair no - 86.45.29 - Bulb
Clock
Remove
1. Remove hazard switch.
See Hazard Warning
Switch and Bulb
2. Disconnect electrical leads from clock.
3. Release bulb holder from clock.
4. Release 3 retaining lugs, remove clock from
surround.
Bulb replacement
5. Withdraw bulb from holder.
Refit
6. Reverse removal procedure.
7. Set clock to correct time.
INSTRUMENT PANEL FINISHER
Service repair no - 88.20.03
Remove
1. Position steering wheel for access.
2. Remove 4 screws securing finisher.
3. Withdraw finisher, disconnect rheostat multiplug.
Refit
4. Reverse removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст