Range Rover Sport. Manual — part 31
Rear Stabilizer Bar Link (64.35.24)
Removal
1
.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle
on safety stands.
Raise and support the vehicle.
2 . Remove the wheel and tire.
3 .
CAUTION: Use a wrench on the hexagon provided to prevent the ball joint rotating.
Remove the stabilizer bar link.
Installation
1 . Install the stabilizer bar link.
Tighten the nuts to 115 Nm (85 lb.ft).
2 . Install the wheel and tire.
Tighten the wheel nuts to 140 Nm (103 lb.ft).
Lower Arm Bushing
Special Service Tools
Receiver rear lower arm front bush
204-526/1
Remover rear lower arm front bush
204-526/2
Installer rear lower arm front bush
204-526/3
Receiver rear lower arm rear bush
204-540/1
Remover rear lower arm rear bush
204-540/2
Removal
NOTE:
The bushings must be replaced in pairs, LH and RH sides.
1
.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle
on safety stands.
Raise and support the vehicle.
2 . Remove the wheels and tires.
3 . Remove the LH lower arm.
For additional information, refer to
Lower Arm (64.35.54)
4 . Remove the RH lower arm.
5 . Note the position of the bushing in relation to the lower arm.
6 .
CAUTION: The bush flanges need to be removed to allow bush removal.
NOTE:
Take note of the fitted position of the bush.
Using a suitable tool, bend over the bush flanges.
7 . Using a hacksaw, remove the flange from the bushing, making sure the upper arm is not damaged.
8 . Using the special tools, remove and discard the lower arm rear bushings.
Installation
1 .
CAUTION: Make sure the bush is correctly aligned.
CAUTION: Make sure the correct special tool is used to install the bushings to the correct depth.
Using the special tools, install the lower arm front bushings
2 .
CAUTION: Make sure the bush is correctly aligned.
Using the special tools, install the lower arm rear bushings.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст