Range Rover Sport. Manual — part 30
1 . Clean the components.
2
.
CAUTION: Ensure the ball joint seal is not damaged. A damaged seal will lead to the premature
failure of the joint.
CAUTION: If the push in force is less than 10 kN the wheel knuckle must be replaced.
Using the special tools, install the ball joint.
Position machined face against the special tool.
3 . Install the wheel knuckle.
For additional information, refer to
Wheel Knuckle (64.35.10)
Rear Stabilizer Bar (64.35.08)
Removal
CAUTION: It is possible to install the stabilizer bar incorrectly. Note the position of the stabilizer bar before
removal.
1
.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle
on safety stands.
Raise and support the vehicle.
2 . Remove the rear bumper cover.
For additional information, refer to
Rear Bumper Cover (76.22.74)
3 . Remove the spare wheel and tire.
4 . Raise the vehicle.
5 . Remove the rear wheels and tires.
6 .
CAUTION: Use a wrench on the hexagon provided to prevent the ball joint rotating.
Release both stabilizer bar links.
Remove the 2 nuts.
7 . Remove the body mount retaining bolts.
Remove the 8 bolts.
CAUTION: Only raise the body sufficiently to remove the body mount.
Raise the body.
Using suitable stands, raise the body to release the body mounts.
9 . Remove the 2 rear body mounts.
10 . Remove the stabilizer bar bushing.
Remove the stabilizer bar clamps.
Remove the 4 bolts.
11 .
CAUTION: Mark the position of the stabilizer bar.
Remove the stabilizer bar.
1 .
CAUTION: Make sure the stabilizer bar is correctly installed.
Install the stabilizer bar.
2 . Install the stabilizer bar bushing.
3 . Install the stabilizer bar clamps.
Tighten the 4 retaining bolts to 62 Nm (46 lb.ft).
4 . Install the body mounts.
5 . Lower the body.
Remove the stands.
6 . Install the body mount retaining bolts.
Tighten the 8 retaining bolts to 133 Nm (98 lb.ft).
7 . Attach both stabilizer bar links.
Tighten the nuts to 115 Nm (85 lb.ft).
8 . Install the wheels and tires.
9 . Lower the vehicle.
10 . Install the spare wheel and tire.
11 . Install the rear bumper cover.
For additional information, refer to
Rear Bumper Cover (76.22.74)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст