Freelander Body Repair Manual — part 36
BODY
8
EXTERIOR FITTINGS
12. Pull sound insulation away from bulkhead for
access to bonnet release cable grommet.
13. Remove grommet from bulkhead.
14. Remove bonnet release cable.
Refit
1. Fit bonnet release cable through bulkhead.
2. Position bonnet release lever.
3. Connect bonnet release cable to lever.
4. Fit release lever to ’A’ post and tighten bolt to 9
Nm.
5. Fit bonnet release cable grommet to bulkhead.
6. Fit cable ties and secure bonnet release to
main harness.
7. Fit sound insulation material to bulkhead.
8. Tie draw string to end of bonnet release cable.
9. Pull on draw string to feed bonnet release
cable through bonnet locking platform.
10. Untie draw string and connect bonnet release
cable to bonnet lock lever.
11. Fit bonnet latch shield and secure with 5 rivets.
12. Fit and tighten radiator threaded retainers in
bonnet locking platform.
Models with air conditioning:
13. Fit condenser.
See AIR CONDITIONING,
Repairs.
All models:
14. Fit front grille.
See this section.
15. Close bonnet and check for correct locking
operation.
BODY
EXTERIOR FITTINGS
9
BUMPER VALANCE - FRONT
Service repair no - 76.22.72
Remove
1. Remove front grille.
See this section.
2. Remove 12 screws securing bumper valance
to body.
3. Remove 3 scrivets from bumper valance.
4. Remove wheelarch liner access panel and
loosen bolts under front of each wing.
5. With assistance, remove bumper valance.
Do not carry out further dismantling if
component is removed for access only.
6. Remove number plate.
BODY
10
EXTERIOR FITTINGS
7. Remove 2 screws from bumper grille.
8. Remove bumper grille.
9. Remove 2 spire nuts.
10. Fit spire nuts to replacement bumper valance.
11. Position bumper grille on replacement bumper
valance and secure with screws.
12. Fit number plate on replacement bumper
valance.
Refit
1. With assistance position bumper valance to
body.
2. Tighten bolts under each front wing to 5 Nm.
3. Fit wheelarch liner access panel.
4. Fit scrivets.
5. Fit screws securing bumper valance to body.
6. Fit front grille.
See this section.
BODY
EXTERIOR FITTINGS
11
BUMPER VALANCE - REAR
Service repair no - 76.22.74
Remove
1. Remove rear mud flaps.
See this section.
2. Remove both tail lamps.
See ELECTRICAL,
Repairs.
3. Remove rear wheel arch extensions.
See this
section.
4. Remove 10 screws securing bumper valance.
5. Remove 5 scrivets securing bumper valance.
6. Remove 2 mud flap brackets.
7. With assistance, remove bumper valance.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст