Freelander Body Repair Manual — part 37
BODY
12
EXTERIOR FITTINGS
Refit
1. With assistance, fit bumper valance. Secure
bumper valance with scrivets and screws.
2. Fit mud flap brackets and secure with screws.
3. Fit rear wheel arch extensions.
See this
section.
4. Fit both tail lamps.
See ELECTRICAL,
Repairs.
5. Fit mud flaps.
See this section.
FINISHER - SILL - LOWER
Service repair no - 76.43.28
Remove
1. Raise front of vehicle.
WARNING: Support on safety stands.
2. Remove both jacking point covers.
3. Remove 7 scrivits securing finisher.
4. Release and remove finisher from sill.
Refit
1. Clean mating faces of finisher.
2. Position finisher to sill, locate over jacking
points and secure with scrivits.
3. Fit jacking point covers.
4. Remove stand(s) and lower vehicle.
BODY
EXTERIOR FITTINGS
13
FINISHER - ROOF PANEL
Service repair no - 76.43.68
Remove
1. Remove tail door glass side finisher.
See
Doors.
2. Remove roof finisher caps or, if roof rack fitted,
remove side rail.
See this section.
3. Using a suitable hooked tool in the front foot
hole of the roof finisher, slide the finisher’s 2
forward clips rearward from the roof channel.
4. Slide the clip rear of the foot hole forward from
the roof channel.
5. Slide the remaining 7 clips from the roof
channel.
6. Remove nut securing rear end of roof finisher.
7. Remove finisher.
BODY
14
EXTERIOR FITTINGS
Refit
1. Fit clips to finisher.
2. Fit finisher to roof channel with forward two
clips.
3. Slide finisher to align with screen. Feed
forward clip below screen seal.
4. Fit remaining clips to roof channel.
5. Fit nut to secure rear end of finisher.
6. Ensure full length of finisher is correctly seated
in roof channel.
7. Fit roof finisher caps or roof rack side rail.
See
this section.
8. Fit tail door glass side finisher.
See Doors.
BODY
EXTERIOR FITTINGS
15
WHEEL ARCH EXTENSION - REAR
Service repair no - 76.43.94
Remove
1. Raise rear of vehicle.
2. Remove road wheel(s).
5 door models
3. Remove 2 scrivets securing extension to edge
of wheel arch.
4. Remove wheel arch extension from 2 fixing
studs.
5. Remove fasteners from arch extension.
3 door models
6. Remove 6 scrivets securing extension to edge
of wheel arch and sill panel.
7. Remove wheel arch extension from 8 fixing
studs.
8. Remove fasteners from arch extension
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст