Freelander Body Repair Manual — part 33
BODY
30
DOORS
HANDLE - EXTERIOR - REAR DOOR
Service repair no - 76.58.02
Remove
1. Remove rear door water shedder.
See this
section.
2. Release door latch control rod.
3. Remove grommet to access screw.
4. Remove 3 Torx screws securing door latch
release and lower latch to access screw.
5. Remove 2 screws securing door handle.
6. Remove door handle.
7. Remove door latch control rod.
Refit
1. Fit door latch control rod to handle.
2. Position handle to door and tighten securing
screws.
3. Position door latch, fit and tighten Torx screws.
4. Fit grommet.
5. Connect door latch control rod.
6. Fit water shedder.
See this section.
BODY
DOORS
31
HANDLE - EXTERIOR - TAIL DOOR
Service repair no - 76.58.05
Remove
1. Remove tail door water shedder.
See this
section.
2. Raise glass by clicking latch.
3. Remove 3 nuts securing handle to tail door.
4. Release handle from tail door.
5. Disconnect 2 Lucars from number plate lamp.
6. Disconnect multiplug from locking mechanism
and remove handle.
7. Collect gasket.
Do not carry out further dismantling if
component is removed for access only.
8. Remove nut from lock barrel.
9. Remove lock barrel from handle.
10. Fit lock barrel to replacement handle. Fit and
tighten nut.
Refit
1. Position gasket on handle.
2. Connect multiplug to handle locking
mechanism.
3. Connect Lucars to number plate lamp.
4. Position housing on door, fit and tighten nuts to
5 Nm.
5. Fit water shedder.
See this section.
6. Reset latch to lower glass.
7. Close door.
BODY
32
DOORS
HANDLE - EXTERIOR - FRONT DOOR
Service repair no - 76.58.07
Remove
3 door models
1. Remove upper water shedder.
See this
section.
5 door models
2. Remove front door water shedder.
See this
section.
All models
3. Release clip securing latch control rod to door
latch, and release rod.
5 door models
4. Remove Torx screws securing door latch,
lower latch and release door lock paddle.
All models
5. Remove grommet to access screw.
6. Remove 2 screws securing door handle.
7. Remove door handle.
8. Remove latch control rod from handle.
Refit
1. Fit door latch control rod to handle.
2. Position handle to door, fit and tighten screws.
3. Fit grommet.
5 door models
4. Position latch, locate door lock paddle, fit and
tighten Torx screws.
All models
5. Connect control rod to door latch.
6. Fit water shedder.
See this section.
BODY
DOORS
33
DOOR PULL - FRONT
Service repair no - 76.58.25
Remove
1. Remove front door casing.
See this section.
2. Remove 4 Torx screws securing door pull to
door casing.
3. Remove door pull.
Refit
1. Position door pull to door casing, fit and tighten
Torx screws.
2. Fit front door casing.
See this section.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст