Harley Davidson Touring Models 84-98 FLH, FLHT, FXR. Service manual — page 7

12A. On 1984-1988 models, tighten the axle nut to 60-65 ft.-lb. (81-88 N*m).

12B. On 1989-1998 models, tighten the axle nut to 60 ft.-lb. (81 N*m). If necessary, tighten the nut to align the hole in the axle with the slot in the nut. Do not exceed 65 ft.-lb. (88 N*m); do not loosen the nut to align the hole and slot. Install a new cotter pin and bend the end over completely.

13. On 1985 models, tighten the anchor bolt (Figure 44) until the rubber plug in the center of the bolt just starts to compress. Then stop. Secure the bolt with a wrench when tightening the locknut to 20 ft.-lb. (27 N*m).

14. Lower the rear wheel to the ground.

15. Install the drive belt debris cover.

16. On models so equipped, install the left side saddlebag as described in Chapter Fifteen.