Jeep Grand Cherokee WK. Manual — part 72
5. Remove axle flange nuts (1) from axle (2).
6. Pull axle shaft and backing plate out of axle tube
until axle bearing (1) is exposed.
7. Remove O-ring (2) from the axle bearing.
3 - 186
REAR AXLE - C213R
WK
8. Slide axle shaft (1) from axle tube and backing
plate.
9. Tap axle shaft out of the bearing and axle flange
through the plug hole with a hammer and brass
drift.
INSTALLATION
1. Tap axle shaft into through axle bearing into axle
flange.
2. Install axle shaft (1) into axle tube and backing
plate with new o-ring on axle.
WK
REAR AXLE - C213R
3 - 187
3. Slip O-ring (2) through backing plate, then push
axle through backing plate until bearing (1) is
exposed.
4. Install O-ring (2) axle bearing.
5. Push axle into axle tube.
6. Install axle (2) flange nuts (1) and tighten to 119
N·m (88 ft. lbs.).
3 - 188
REAR AXLE - C213R
WK
7. Install speed sensors (2) in axle tube (1) flange.
8. Coat new axle flange plug with Mopar
T
Stud N’
Bearing Mount Adhesive or equivalent and install
plug.
9. Install calipers and rotors.
AXLE BEARINGS
REMOVAL
1. With vehicle in netural, position on hoist.
2. Remove calipers and rotors.
3. Tap axle end plug (1) loose from the wheel flange
(2) with a hammer and punch. Pull plug (1) out of
wheel flange (2).
WK
REAR AXLE - C213R
3 - 189
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст