Jeep Grand Cherokee WK. Manual — part 1608
38. Using a trim stick C-4755 or equivalent, remove
the defroster grills (2).
39. Remove the two fenceline nuts (1).
40. Using a trim stick C-4755 or equivalent, remove
the radio bezel.
41. Using a trim stick C-4755 or equivalent, remove
the center bezel and disconnect the electrical con-
nectors.
42. Remove the nut from the HVAC support stud
behind the center bezel.
43. Remove the screw to the HVAC from under the
glove box opening.
23 - 90
INSTRUMENT PANEL
WK
44. Remove the HVAC bracket bolt from the glove
box opening.
45. Remove the left and right center support brackets.
* Left side shown, right side similar.
46. Remove the center floor duct (3).
WK
INSTRUMENT PANEL
23 - 91
47. Remove the radio.
48. Remove the two HVAC bolts from the radio open-
ing.
49. Remove the instrument panel assembly.
INSTALLATION
1. Before proceeding with installation of the instru-
ment panel assembly, remove the load clips from
each a-pillar and install onto the sides of the panel
using the screw.
2. Place the instrument panel into the vehicle and
position onto the a-pillars using the load clips (2).
3. Install the two bolts on the right side and tighten
the bolts to 11 N·m (95 in. lbs.).
23 - 92
INSTRUMENT PANEL
WK
4. Install the two fenceline nuts (1).
5. Guide the peddle support studs (3) on the drivers
side, into the slots in the instrument panel rein-
forcement.
6. Position the center stack brackets (2) in front of the
duct work.
WK
INSTRUMENT PANEL
23 - 93
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст