Jeep Grand Cherokee WK. Manual — part 1609
7. Rotate the instrument panel back and guide the
HVAC stud.
8. Continue to rotate the instrument panel back and
guide the tube brackets located in the radio open-
ing, into the HVAC.
9. Install the screw at the bottom of the column open-
ing next to the center stack up from the bottom
attaching the HVAC.
23 - 94
INSTRUMENT PANEL
WK
10. Install the bolt at the HVAC blower motor housing.
11. Install the screw at the bottom of the glove box opening to the blower motor housing support.
12. Snap the lower glove box hinges (2) over the piv-
ots (1) and rotate up.
13. Push the stop tabs down and close the glove box.
WK
INSTRUMENT PANEL
23 - 95
14. Connect the right side wiring.
15. Install the right hush panel trim.
16. Install the right cowl trim and position the door
seal back.
17. Position the right side door sill trim and seat fully.*
Left side shown, right side similar.
23 - 96
INSTRUMENT PANEL
WK
18. Install the right a-pillar trim, the bolts and position
the door seal back.
19. Install the two bolts on the left side and tighten to
11 N·m (95 in. lbs.).* Right side shown, left side
similar.
20. Position the right side end cap and seat fully.* Left
side shown, right side similar.
WK
INSTRUMENT PANEL
23 - 97
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст