Jeep Grand Cherokee WK. Manual — part 88
INSTALLATION
1. Install axle flange bolts into axle flange.
2. Tap axle shaft through axle bearing into wheel
flange.
3. Install axle shaft (1) into axle tube and backing
plate with new o-ring on axle.
4. Slip O-ring (2) through backing plate, then push
axle through backing plate until bearing (1) is
exposed.
5. Install O-ring (2) axle bearing.
3 - 250
REAR AXLE - C213RE
WK
6. Push axle into axle tube.
7. Install axle (2) flange nuts (1) and tighten to 119
N·m (88 ft. lbs.).
8. Install speed sensors (2) in axle tube (1) flange.
9. Coat new axle flange plug with Mopar
T
Stud N’
Bearing Mount Adhesive or equivalent and install
plug.
10. Install calipers and rotors.
WK
REAR AXLE - C213RE
3 - 251
AXLE SHAFT SEALS
REMOVAL
1. With vehicle in netural, position on hoist.
2. Remove calipers and rotors.
3. Remove speed sensors (2) from axle tube (1)
flange.
4. Remove axle flange nuts (1) from axle (2).
3 - 252
REAR AXLE - C213RE
WK
5. Pull axle shaft and backing plate out of axle tube
until axle bearing (1) is exposed.
6. Remove O-ring (2) from the axle bearing.
7. Remove axle shaft (1) from axle tube and backing
plate.
WK
REAR AXLE - C213RE
3 - 253
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст