Jeep Grand Cherokee WK. Manual — part 1548
4. Start front output shaft bearing in the front housing.
Using Installer 8152 (2), inverted, and Handle
C-4171 (1), seat the bearing in the front housing
(3).
5. Remove the rear output shaft bearing from the rear
case using Installer 5066 and Handle C-4171.
6. Install the rear output shaft bearing into the rear
housing (3) using Installer 8152 (2), inverted, and
Handle C-4171 (1).
7. Install the input gear (2) into the front housing (1).
8. Install the new input shaft seal with Installer 9672
and Handle C-4171.
21 - 1002
TRANSFER CASE - NV140 - SERVICE INFORMATION
WK
9. Install a new front output shaft seal with Installer
6560.
10. Install the front output shaft (2) into the front
housing (1) and the front output shaft front
bearing.
11. Install the retaining ring (2) onto the front output
shaft (1).
12. Lubricate mainshaft splines with recommended
transmission fluid.
NOTE: Replace the mode hub retainer if the legs
were distorted during removal.
13. Install the mode hub retainer (1) onto the mode
hub (2).
WK
TRANSFER CASE - NV140 - SERVICE INFORMATION
21 - 1003
14. Install the mode hub (2) and mode hub retainer
onto the differential assembly (1). Make sure the
retainer is fully seated onto the differential.
15. Install the differential assembly (1) onto the main-
shaft (2).
16. Install the differential snap-ring (1).
21 - 1004
TRANSFER CASE - NV140 - SERVICE INFORMATION
WK
17. Install the drive chain guide (1) onto the transfer
case.
18. Install the screws (2) to hold the chain guide rail
(1) to the front housing. Tighten the screws to 5-8
N·m (44-71 in.lbs.).
19. Install the input gear thrust washer (1) onto the
input gear (2).
WK
TRANSFER CASE - NV140 - SERVICE INFORMATION
21 - 1005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст