Jeep Grand Cherokee WK. Manual — part 46
INSTALLATION
1. Install axle bushing (1) with Installer 5063 (2) and
hammer.
2. Install axle shaft and seal.
PINION SEAL
REMOVAL
1. Remove wheels.
2. Push back brake pads and release hand brake.
3. Remove propeller shaft.
4. Rotate pinion with inch pound torque and record
torque to rotate.
5. Mark installation position of collared nut with
respect to drive pinion.
6. Bend pinion nut lock back with a punch and ham-
mer.
7. Hold pinion flange (1) with Wrench C-3281(2) and
remove pinion nut.
3 - 82
FRONT AXLE - C200F
WK
8. Remove pinion flange (1) with Puller C-452 (2).
9. Remove pinion seal with a seal pick.
INSTALLATION
1. Install pinion seal with Installer C-3972A and Han-
dle C-4171.
2. Install pinion flange (1) on pinion with Installer 9616
(2). Tap flange on pinion, then thread installer cen-
ter bolt on pinion shaft and draw flange onto the
pinion.
WK
FRONT AXLE - C200F
3 - 83
3. Install new pinion collared nut and carefully tighten
nut in stages holding flange (1) with Wrench
C-3281(2). Check torque to rotate after each stage,
until
previously
value
of
torque
to
rotate
is
exceeded by 0.5 N·m. (4.4 in. lbs.).
4. Cut the pinion nut collar.
5. Bend nut collar so it touches the wall of the slot in
the pinion shaft.
6. Connect propeller shaft to pinion flange.
7. Install wheel and tires.
8. Operate brake pedal several times until brake pads
contact brake discs (brake pressure built up).
3 - 84
FRONT AXLE - C200F
WK
BUSHINGS-AXLE
REMOVAL
1. Remove axle from vehicle.
2. Remove pinion flange.
3. Remove pinion nose bushing with Press C-4212F
(1) Receiver 9536 (2) and Remover 9512 (3).
4. Remove axle tube bushing with Press C-4212F (1)
Receiver 9536 (2) and Remover 9512 (3).
WK
FRONT AXLE - C200F
3 - 85
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст