Jeep Grand Cherokee WK. Manual — part 42
4. Install differential bushing bolt and nut. Tighten nut
to 95 N·m (70 ft. lbs.)
5. Install differential vent hose.
6. Install half shaft into axle and knuckles. Verify axle
are engaged in the axle.
7. Install clevis (3) bolt and nut (4) on lower control
arms and tighten to specification.
3 - 66
FRONT AXLE - C200F
WK
8. Install upper control arms on knuckles and tighten
ball joint nuts to specifications.
9. Install tie rod ends (4) and nuts (5) on knuckles
and tighten to specifications.
10. Install stabilizer bar links (2) and bolts (6) on
lower control arms and tighten to specifications.
11. Install brake calipers on knuckles.
12. Install wheel speed sensor (1) on hub/bearing (3).
13. Install half shaft hub nuts and tighten to 135 N·m
(100 ft. lbs.).
14. Install propeller shaft on pinion flange with refer-
ence marks aligned.
15. Install drain plug and tighten to 60 N·m (44 ft.
lbs.).
16. Fill differential housing and install fill plug. Tighten
plug to 60 N·m (44 ft. lbs.).
17. Install skid plate.
WK
FRONT AXLE - C200F
3 - 67
ADJUSTMENTS
ADJUSTMENT
PINION DEPTH MEARSUREMENT
NOTE:
Take
measurement
with
pinion
shim
removed and rear bearing cup in place.
1. Install Pinion Height Block 6739 (3), Pinion Block
9534 (2), and pinion head bearing cone (1) onto
Screw 6741. Install assembly into axle housing and
through bearing and cups.
2. Install pinion front bearing and Cone 6740. Tighten
Cone 6740 by hand until 3.4 N·m (30 in. lbs.) of
rotating torque is measured at Screw 6741.
3. Install Arbor Discs 9538 (1).
3 - 68
FRONT AXLE - C200F
WK
4. Install Arbor Bar D-115-3 (1).
5. Verify pinion depth setup is as shown.
WK
FRONT AXLE - C200F
3 - 69
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст