Jeep Grand Cherokee WK. Manual — part 1605
INSTALLATION
1. Snap the lower glove box hinges (2) over the piv-
ots (1) and rotate up.
2. Push the stop tabs down and close the glove box.
COVER-STEERING COLUMN OPENING
REMOVAL
1. Disconnect and isolate battery negative cable.
2. Remove the bolts (3) and remove the drivers side
hush panel (2).
23 - 78
INSTRUMENT PANEL
WK
3. Using a trim stick C-4755 or equivalent, separate
the upper clips and rotate the cover down and
release the lower hinges at the bottom and remove
the opening cover.
INSTALLATION
1. Snap the lower steering column opening cover
hinges over the pivots and rotate up.
2. Seat the upper fastener clips fully.
WK
INSTRUMENT PANEL
23 - 79
3. Install the hush panel (2) and install the screws (3).
ASSEMBLY-INSTRUMENT PANEL
REMOVAL
1. Before proceeding with the following repair proce-
dure, review all warnings and cautions. (Refer to
23 - BODY/INSTRUMENT PANEL - WARNING)
2. Disconnect and isolate battery negative cable.
3. Remove the bolts (3) and remove the drivers side
hush panel (2).
23 - 80
INSTRUMENT PANEL
WK
4. Using a trim stick C-4755 or equivalent, separate
the upper clips and rotate the cover down and
release the lower hinges at the bottom and remove
the opening cover.
WARNING: BEFORE SERVICING THE STEERING
COLUMN THE AIRBAG SYSTEM MUST BE DIS-
ARMED. FAILURE TO DO SO MAY RESULT IN
ACCIDENTAL DEPLOYMENT OF THE AIRBAG AND
POSSIBLE PERSONAL INJURY. (Refer to 8 - ELEC-
TRICAL/RESTRAINTS/DRIVER
AIRBAG
-
REMOVAL).
5. Remove the three bolts in the lower shroud (2).
NOTE: Use care not to break off the tangs on the
shrouds.
6. Then unsnap the lower shroud (2) from the upper
shroud (1).
7. Disconnect the steering column electrical connec-
tors (3).
WK
INSTRUMENT PANEL
23 - 81
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст