Jeep Grand Cherokee WK. Manual — part 1603
LATCH
REMOVAL
1. Using a grease pencil or equivalent, mark the posi-
tion of the hood latch (1) on the upper radiator
crossmember.
2. Remove the two bolts (2) that secure the hood
latch (1) to the upper radiator crossmember.
3. Disconnect the hood latch cable (2 and 3) from the
hood latch (1).
23 - 70
HOOD
WK
INSTALLATION
1. Connect the hood latch cable (2 and 3) to the hood
latch (1).
2. Position the hood latch (1) to the upper radiator
crossmember and loosely install the two nuts (2)
that secure the latch to the crossmember.
3. Align the hood latch (1) to the upper radiator cross-
member using the reference marks made during
the Removal procedure and tighten the bolts to 11
N·m (8 ft. lbs.).
4. If required, adjust the hood to the correct position
(Refer to 23 - BODY/BODY STRUCTURE/GAP
AND FLUSH - SPECIFICATIONS).
WK
HOOD
23 - 71
RELEASE-HOOD LATCH
REMOVAL
1. Remove the hood latch (Refer to 23 - BODY/
HOOD/LATCH - REMOVAL).
2. Remove release cable (2) from the three hood
release cable retainers (1).
3. From inside the vehicle, remove the two bolts (2)
that secure the hood release handle (1) to the cowl
trim panel.
4. Remove the grommet from the cowl panel and
remove the hood release cable and handle assem-
bly (1).
INSTALLATION
1. Route the hood release cable through the cowl
panel and install the grommet.
2. Position the hood release handle (2) onto the cowl
trim panel.
3. Install the two bolts (2) that secure the hood
release handle (1) to the instrument panel bracket.
Tighten the bolts to 9 N·m (80 in. lbs.).
23 - 72
HOOD
WK
4. Route the hood release cable (2) along the left
inner fender and the upper radiator crossmember
and install the three hood release cable retainers
(1).
5. Install the hood latch (Refer to 23 - BODY/HOOD/
LATCH - INSTALLATION).
CYLINDER-HOOD SUPPORT
REMOVAL
NOTE: Lift the clips only enough to release the
ball studs (1).
1. Support hood.
2. Disconnect the hood support cylinder (2) from the
hood and the ball stud (1) on the fender rail.
3. If required, remove the upper ball stud from hood
and the lower ball stud (1) from the fender rail.
WK
HOOD
23 - 73
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст