Jeep Grand Cherokee WK. Manual — part 77
3. Position Puller (1) Jaws 9639 (2) around the case
bearing and puller flange.
4. Position Puller (1) Collar 6444-8 (2) around the
puller jaws.
5. Tighten the puller nut and remove differential case
bearing.
3 - 206
REAR AXLE - C213R
WK
INSTALLATION
1. Install differential case bearing with Installer C-4340
(1) and Handle C-4171 (2).
CAUTION:
Vari-lok
T
,
plenum
must
be
seated
against the differential case, prior to installing the
ring gear side differential bearing. Failure to follow
these
instructions
will
damage
the
Vari-lok
T
plenum.
WK
REAR AXLE - C213R
3 - 207
BEARINGS-DIFFERENTIAL CASE
REMOVAL
1. Remove differential case from axle.
2. Remove differential bearings (3) from the case with
Puller/Press C-293-PA (1) and Adapters C-293-48
(2) and Plug SP-3289 (5).
INSTALLATION
1. Install differential side bearings (3) with Installer
C-4340 (4) and Handle C-4171 (1).
2. Install differential case in axle.
3 - 208
REAR AXLE - C213R
WK
PINION GEAR/RING GEAR
REMOVAL
NOTE: The ring gear and pinion are serviced in a
matched set. Never replace one gear without
replacing the matching gear.
1. Remove differential from axle housing.
2. Place differential case in vise with soft metal jaw
protectors.
3. Remove ring gear bolts and drive ring gear (2) off
differential case with a soft hammer (3).
4. Hold
pinion
flange
with
Wrench
C-3281
and
remove pinion nut.
5. Remove pinion flange with two jaw puller.
6. Remove pinion from housing with a soft hammer
(1).
WK
REAR AXLE - C213R
3 - 209
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст