Jeep Grand Cherokee WK. Manual — part 50
8. Lube new o-ring and install on axle tube (1).
9. Align axle tube (1) with differential housing flange
(3) and push tube into place.
CAUTION: The tube must be perfectly aligned to
the housing to prevent damage to the o-ring. Fail-
ure to follow these instructions will result in a
leak.
10. Install axle tube (1) bolts (2) and tighten to 56
N·m (41 ft. lbs.).
11. Install half shaft seal with Installer 9504 and Han-
dle C-4171.
12. Apply a 6.35 mm (1/4 in.) bead of Mopar
T
Gear
Sealant
RTV
Silicone
Rubber
Adhesive
MS-GF44D or equivalent to the differential case.
CAUTION: If housing cover is not installed within
3 to 5 minutes, the differential case must be
cleaned and new RTV applied. Failure to follow
these instructions will result in a leak.
13. Install cover and tighten cover bolts in a criss-
cross pattern to 56 N·m (41 ft. lbs.).
SEAL-DIFFERENTIAL
REMOVAL
1. Remove half shaft from axle.
2. Pry seal out with a seal pick.
INSTALLATION
1. Install differential seal with Install 9504 and Handle C-4171.
2. Install half shaft.
3 - 98
FRONT AXLE - C200F
WK
DIFFERENTIAL CASE BEARINGS
REMOVAL
1. Remove differential from housing.
2. Remove differential bearings with Puller C-293-PA
(1), Plug C-293-3 (2) and four Adapters C-293-48
(3).
INSTALLATION
1. Install differential case (2) bearings (3) with Installer
9535 (4) and Handle C-4171(1).
2. Install differential into the housing.
WK
FRONT AXLE - C200F
3 - 99
PINION GEAR/RING GEAR/TONE RING
REMOVAL
1. Remove differetial from housing.
2. Bend pinion nut lock tab back.
3. Remove pinion flange (1) nut with flange Holder
C-328 (2).
4. Remove pinion flange (1) with Puller C-452 (2).
3 - 100
FRONT AXLE - C200F
WK
5. Drive pinion gear out of the housing with a soft
hammer.
6. Remove pinion seal (1) with a pry bar (2).
7. Remove collapsible spacer (1) from pinion shaft
(2).
WK
FRONT AXLE - C200F
3 - 101
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст