Jeep Liberty KJ. Manual — part 1290
WINDOW REGULATOR - POWER
REMOVAL
1. Remove the waterdam. (Refer to 23 - BODY/
DOOR - FRONT/WATERDAM - REMOVAL)
2. Raise the glass (4) to the position shown and using
a long flat blade or hook type tool, disengage clips
(1) attaching glass retainer to regulator lift plate (3).
3. Disconnect the glass (4) from the regulator lift plate
and re-install the clips (1).
4. Secure the glass in the up position using a wood
wedge, tape or equivalent.
23 - 60
DOOR - FRONT
KJ
5. Loosen the bolts (1, 2 and 4).
6. Disconnect the runout tube clip (3).
7. Disconnect the electrical connector and remove the
regulator (5).
INSTALLATION
1. Install the regulator assembly (5).
2. Connect the electrical connector.
3. Connect the runout tube clip (3).
KJ
DOOR - FRONT
23 - 61
4. Tighten the bolts to 9 N·m (80 in. lbs.) using the
sequence shown.
5. Remove the glass support and connect to the reg-
ulator lift plate (3).
6. Install the waterdam. (Refer to 23 - BODY/DOOR -
FRONT/WATERDAM - INSTALLATION)
23 - 62
DOOR - FRONT
KJ
DOORS - REAR
TABLE OF CONTENTS
page
page
CHECK STRAP
DOOR
DOOR GLASS
EXTERIOR HANDLE
GLASS RUN CHANNEL
HINGE
LATCH
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 79
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80
ADJUSTMENTS
ADJUSTMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 81
LATCH STRIKER
TRIM PANEL
WATERDAM
WINDOW REGULATOR - MANUAL
WINDOW REGULATOR - POWER
KJ
DOORS - REAR
23 - 63
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст