Jeep Liberty KJ. Manual — part 299
DISASSEMBLY
1. Rotate one pinion gear (2) with thrust washer (3) to
the differential window (1) and remove gear and
thrust washer.
2. Rotate remaining pinion gear (3) with thrust washer
(2) to the differential window (1) and remove gear
and washer.
3 - 100
REAR AXLE - 8 1/4
KJ
3. Remove differential side gears (1) (2) and thrust
washers.
ASSEMBLY
NOTE: If same gears and thrust washers are being
used, install them into their original locations.
1. Lubricate all differential components with axle lubri-
cant.
2. Install differential side gears (2) and thrust washers
through differential window (1).
KJ
REAR AXLE - 8 1/4
3 - 101
3. Install first pinion gear (3) with thrust washer into
differential window (1) and side gears (2). Rotate
pinion gear into the case.
4. Install remaining pinion gear (2) and thrust washer
(3). Rotate gears to align hole in the pinion gears
with hole in the differential case.
3 - 102
REAR AXLE - 8 1/4
KJ
5. Slide pinion shaft (1) into the case and through the
pinion gears (3) to align the gears.
INSTALLATION
1. Apply a coat of hypoid gear lubricant to differential
bearings, bearing cups and threaded adjusters.
NOTE: Grease can be used to keep the adjusters
in position.
2. Install differential assembly into the housing.
3. Install differential bearing caps in their original loca-
tions.
4. Install bearing cap bolts (2) and tighten upper bolts
to 14 N·m (10 ft. lbs.). Tighten lower bolts finger-
tight until bolt head is seated.
5. Perform differential bearing preload and adjustment
procedure.
6. Tighten bearing cap bolts in a criss-cross pattern to
95 N·m (70 ft. lbs.).
7. Install adjuster locks (3) on bearing caps and
tighten to 10 N·m (90 in. lbs.).
8. Install axle shafts.
9. Install differential cover.
KJ
REAR AXLE - 8 1/4
3 - 103
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст