Jeep Liberty KJ. Manual — part 300
BEARING-DIFFERENTIAL CASE
REMOVAL
1. Remove differential case from axle.
2. Remove differential bearings (3) from the case with
Puller/Press C-293-PA (1) and Adapters C-293-48
(2) and Plug SP-3289 (5).
INSTALLATION
1. Install differential (2) bearings (3) with Installer
C-4340 (4) and Handle C-4171(1).
2. Install differential case in axle.
3 - 104
REAR AXLE - 8 1/4
KJ
GEAR-PINION/RING
REMOVAL
NOTE: The ring and pinion gears are serviced in a
matched set. Never replace one gear without
replacing the other matched gear.
1. Remove differential from axle housing.
2. Place differential case (1) in a vise with soft metal
jaw.
3. Remove bolts holding ring gear (2) to differential
case.
4. Drive ring gear from differential case with a dead-
blow hammer (3).
5. Hold flange (1) with Holder 6719A and remove
flange nut and washer.
6. Remove flange (1) from pinion shaft with Puller
C-452 (2).
KJ
REAR AXLE - 8 1/4
3 - 105
7. Remove pinion from the housing with dead-blow
hammer (1).
8. Remove pinion shaft seal with a seal pick.
9. Remove oil slinger, if equipped, and front pinion
bearing.
10. Remove front pinion bearing cup with Remover
C-4345 (1) and Handle C-4171 (2).
3 - 106
REAR AXLE - 8 1/4
KJ
11. Remove rear bearing cup with Remover C-4307
(1) and Handle C-4171 (2).
12. Remove collapsible spacer (1) from pinion (3).
KJ
REAR AXLE - 8 1/4
3 - 107
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст