Jeep Liberty KJ. Manual — part 1279
SPECIAL TOOLS
BODY
Trim Stick C-4755
TORX BIT SET C-4794-B
REMOVER, MOLDINGS C-4829-A
Outer Belt Molding Remover - 9093
23 - 16
BODY
KJ
HOOD
TABLE OF CONTENTS
page
page
HINGE
HOOD
LATCH
LATCH RELEASE CABLE
SUPPORT CYLINDER
LATCH RELEASE HANDLE
KJ
HOOD
23 - 17
HINGE
REMOVAL
NOTE: It is not necessary to remove the hood to
replace one or both hinges. The hinges can be
replaced one at a time.
1. Raise and support hood.
2. Using a grease pencil or equivalent, mark position
of hinge (1).
3. Remove hood support cylinder (4). (Refer to 23 -
BODY/HOOD/SUPPORT CYLINDER - REMOVAL)
4. Remove bolts (3) attaching hinge (1) to body.
5. Remove bolts (1) attaching hinge (2) to hood.
6. Separate hinge from vehicle.
23 - 18
HOOD
KJ
INSTALLATION
1. Position hinge (2) on vehicle and align reference
marks.
2. Install the bolts (1) attaching hinge to hood and
tighten to 12 N·m (9 ft. lbs.).
3. Install bolts (3) attaching hinge to body and tighten
to 28 N·m (21 ft. lbs.).
4. Install hood hinge support cylinder (4). (Refer to 23
- BODY/HOOD/SUPPORT CYLINDER - INSTAL-
LATION)
KJ
HOOD
23 - 19
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст