Jeep Liberty KJ. Manual — part 276
SPECIAL TOOLS
INCLINOMETER 7663
3 - 8
PROPELLER SHAFT
KJ
SHAFT-PROPELLER FRONT
REMOVAL
REMOVAL – 2.8L DIESEL
1. With vehicle in neutral, position vehicle on hoist.
2. Remove left side exhaust flange (1) bolts.
3. Mark companion flanges (3) and C/V joints at the
front (2) and rear of the propeller shaft for installa-
tion reference.
4. Remove bolts (1) from the front and rear C/V joints.
5. Push propeller shaft forward to clear transfer case
companion flange (2).
6. Remove shaft from the front axle companion
flange.
7. Pull down on the exhaust and tilt the front of the
shaft down and pull shaft forward and remove from
the vehicle.
REMOVAL - 3.7L GAS ENGINE
1. With vehicle in neutral, position vehicle on hoist.
2. Mark companion flanges and C/V joints at the front
and rear of the propeller shaft for installation refer-
ence.
3. Remove bolts (1) from the front and rear C/V joints
(2).
4. Push propeller shaft forward to clear transfer case
companion flange.
5. Remove shaft from the front axle companion
flange.
6. Tilt the front of the shaft down and pull shaft for-
ward and remove from the vehicle.
KJ
PROPELLER SHAFT
3 - 9
INSTALLATION
INSTALLATION – 2.8L DIESEL
1. Install propeller shaft between companion flanges.
2. Align marks on the companion flanges with the
marks on the C/V joints.
3. Install front C/V joint bolts and tighten to 30 N·m
(22 ft. lbs.).
4. Install rear C/V joint bolts (1) and tighten to 30 N·m
(22 ft. lbs.).
5. Install exhaust flange (1) and bolts.
INSTALLATION - 3.7L GAS ENGINE
1. Install propeller shaft between companion flanges.
2. Align marks on the companion flanges with the
marks on the C/V joints.
3. Install front C/V joint bolts and tighten to 30 N·m
(22 ft. lbs.).
4. Install rear C/V joint bolts (1) and tighten to 30 N·m
(22 ft. lbs.).
3 - 10
PROPELLER SHAFT
KJ
SHAFT-PROPELLER REAR
REMOVAL
1. With vehicle in neutral, position vehicle on hoist.
2. Mark a reference line (3) across companion flanges
(2) (4) and propeller shaft (1) for installation.
3. Pry open clamp holding the dust boot (2) to propel-
ler shaft yoke, if equipped.
KJ
PROPELLER SHAFT
3 - 11
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст