Jeep Liberty KJ. Manual — part 1346
AIR INLET SEAL
REMOVAL
1. Open the hood and carefully disengage the push pin fasteners and remove the seal.
INSTALLATION
1. Position the seal and seat the push pin fasteners fully.
23 - 284
WEATHERSTRIP/SEALS
KJ
FRONT DOOR INNER BELT WEATHERSTRIP
REMOVAL
1. Remove the door trim panel. (Refer to 23 - BODY/DOOR - FRONT/TRIM PANEL - REMOVAL)
2. Rotate the outer belt molding outboard while pulling up to disengage the retention tabs.
INSTALLATION
1. Press the belt molding onto the trim panel flange starting at the rear and working forward.
2. Install the door trim panel. (Refer to 23 - BODY/DOOR - FRONT/TRIM PANEL - INSTALLATION)
KJ
WEATHERSTRIP/SEALS
23 - 285
REAR DOOR INNER BELT WEATHERSTRIP
REMOVAL
1. Remove the door trim panel. (Refer to 23 - BODY/DOORS - REAR/TRIM PANEL - REMOVAL)
2. Rotate the outer belt molding outboard while pulling up to disengage the retention tabs.
INSTALLATION
1. Press the belt molding onto the trim panel flange starting at the rear and working forward.
2. Install the door trim panel. (Refer to 23 - BODY/DOORS - REAR/TRIM PANEL - INSTALLATION)
23 - 286
WEATHERSTRIP/SEALS
KJ
BODY STRUCTURE
TABLE OF CONTENTS
page
page
ASSEMBLY
SPECIFICATION . . . . . . . . . . . . . . . . . . . . . . . . . . . 288
WELD AND STRUCTURAL ADHESIVE
LOCATIONS
SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . 291
SEALER LOCATIONS
SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . 369
OPENING DIMENSIONS
SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . 392
GAP AND FLUSH
SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . 396
KJ
BODY STRUCTURE
23 - 287
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст