Iveco Daily. Manual — part 418
198
ELECTRIC/ELECTRONIC SYSTEM
D
AILY
Base - May 2004
The fan is provided with an electromagnetic junction
monitored by the electronic centre pin A39 that activated
the junction remote control switch, to optimise water
cooling.
The electrical fan remote control switch is activated or
deactivated by the centre according to the temperature of:
- the coolant
- over supply air
- the fuel
Engine coolant temperature
Activated at over 96 °C and deactivated at under 84 °C
Over supply air temperature
Activated at over 75 °C and deactivated at under 65 °C
Fuel temperature
Activated at over 20 °C and deactivated at under 10 °C
ELECTROMAGNETIC JUNCTION TECHNICAL VIEW
1. Coil - 2. Connector
Figure 225
88064
ELECTRIC/ELECTRONIC SYSTEM
199
D
AILY
CLIMATE CONTROL
General
The function of the system is to automatically or manually
control the temperature required in the cab.
According to the set required temperature the system
controls:
- automatically:
air vent temperature
fan speed (continuous changing)
- manually:
fan speed
compressor on/off
outside air inlet/re-circulation
MAX DEF function (defrosting);
- totally manually (through bowden cables):
distribution of air flows to the air vents.
AIR FLOW DISTRIBUTION INSIDE THE CAB
Figure 226
000250t
200
ELECTRIC/ELECTRONIC SYSTEM
D
AILY
Base - May 2004
A special electronic control unit controls automatic system
operation checking the various parameters in order to
provide the comfort required in the cab.
The control unit carries out and sets certain functions to
obtain adaptation of the temperature of the cab to the one
required depending on the requests received and the
temperature conditions detected.
CLIMATE CONTROL ELECTRONIC CONTROL UNIT CONNECTIONS
1. Controls on dashboard: inside temperature sensor, re-circulation switch, "eco" switch, fan control potentiometer -
2. Outside temperature sensor - 3. Evaporator sensor - 4. Blown air sensor - 5. Digital display - 6. Fan electronic control
module - 6A. Fan - 7. Compressor - 8. Gear motor for re-circulation function - 9. Air mixing gear motor -
10. Diagnostic connector - 11. EDC-EGR control unit - 12. Climate control electronic control unit
TEMP
–
kml
9
22
29
35
38
36
30
23
17
10
4
1
3
16
1
3
2
4
11
12
5
10
6A
7
8
9
6
Figure 227
000251t
ELECTRIC/ELECTRONIC SYSTEM
201
D
AILY
DETAIL OF AIR DISTRIBUTION KNOB
VENTILATION AND HEATING CONTROLS ASSEMBLY
1. Temperature adjustment knob - 2. Fan speed control knob - 3. Air distribution knob - 4. Outside air inlet or re-circulation
Air distribution knob
A. Face area vents
B. Face and floor area vents
C. Floor area vents
D. Floor and windscreen area vents
E. Windscreen area vents
A
B
C
D
E
1
2
3
4
Figure 228
Figure 229
000252t
000241t
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст