Iveco Daily. Manual — part 229
10
PROPELLER SHAFTS
D
AILY
Base - May 2004
TORQUE
PART
Nm
kgm
Ring nut for fixing to connecting shaft
250
± 25
25.4
± 2.5
Nut for screw for fixing flanges to propeller shaft
M10 x 1,5
M12 x 1.25
63.5
± 6.5
116.5
± 11.5
6.5
± 0.6
11.8
± 1.2
Nut, linkage shaft to chassis side member fixing screw
62.5
± 6.5
6.3
± 0.6
TOOLS
TOOL NO.
DESCRIPTION
99370618
Support for removal-refitting propeller shaft
YES
NO
Elastic dowel of central support in bad condition.
Replace the support.
Central elastic support bearing in bad condition or
excessive play.
Replace the support.
Flange fixing screws or ring nuts on propeller shaft tang
loose.
Tighten the screws or the ring nuts to required driving
torque.
YES
NO
YES
TIGHTENING TORQUES
Arrange the support 99370618 on the hydraulic jack and
apply the support to the propeller shaft.
Remove the fixing bolts from the flange and remove the shaft;
for the intermediate and front axles, also remove the chassis
shaft support.
Refitting
52123
52124
Figure 6
Figure 7
The plates welded to the propeller shafts are counterweights.
If the plates are missing the shaft must be re-balanced.
By operating on the propeller shaft and at the same time, in
the opposite direction, on the sliding sleeve, check that there
is not too much slack between the splines.
By operating on the sleeve forks. check that the spiders are
not worn; if they are, replace them.
Removal
When overhauling the propeller shaft, always begin
by removing the rear shaft.
CHECKING PROPELLER SHAFTS ON
VEHICLE
Repeat the same operations for removal in the opposite
order and observe the following:
- make sure that the arrows shown on the moving part
and on the shaft are aligned;
- make sure that the holes of the front flange are aligned
with those of the rear flange;
- the nuts for the flange coupling screws must be replaced
and never reused;
- the flange coupling screws must be inserted into the
holes of the flange from the side of the universal joint;
- the nuts and screws must be tightened to the required
driving torque;
- the flange of the moving part of the propeller shaft must
be connected to the output shaft flange.
NOTE
PROPELLER SHAFTS
11
D
AILY
505620
PROPELLER SHAFT REMOVAL AND REFITTING
12
PROPELLER SHAFTS
D
AILY
Base - May 2004
Revi - February 2005
REAR AXLES
1
D
AILY
Base - May 2004
SECTION 6
5250
Rear axles
Page
DIAGNOSTICS
3
. . . . . . . . . . . . . . . . . . . . . . . . . .
REAR AXLE 450210
5
. . . . . . . . . . . . . . . . . . . . . .
REAR AXLES 450311/1 - 450511
35
. . . . . . . . . . . .
REAR AXLE 450517/2
61
. . . . . . . . . . . . . . . . . . . .
REAR AXLE 450310
91
. . . . . . . . . . . . . . . . . . . . . .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст