Iveco Daily. Manual — part 440
286
ELECTRIC/ELECTRONIC SYSTEM
D
AILY
Base - May 2004
To replace the module, proceed as follows:
1. Remove the upper trim working on the three screws
shown by the arrows.
2. Lift and remove the trim taking care not to damage the
velcro stoppers.
UPPER TRIM FASTENING SCREW
UPPER TRIM FASTENING SCREW
UPPER TRIM FASTENING SCREW
TRIM REMOVAL
INSTRUMENT CLUSTER
Figure 335
8787
Figure 336
8788
8790
Figure 337
8789
8791
Figure 338
Figure 339
ELECTRIC/ELECTRONIC SYSTEM
287
D
AILY
Work on the 4 screws, 2 on either side, to remove the cluster
module with tachometer.
Disconnect the electrical connections and replace with the
module for tachograph sealing the electrical connections
concerning the wiring for tachograph.
Fasten the instrument cluster to the dashboard and refit the
upper and lower trim.
INSTRUMENT CLUSTER FASTENING
REMOVING THE INSTRUMENT CLUSTER
CONNECTIONS CONCERNING WIRING FOR
TACHOGRAPH
COMPLETE INSTRUMENT CLUSTER
Figure 340
8792
Figure 341
8793
8794
8795
Figure 342
Figure 343
288
ELECTRIC/ELECTRONIC SYSTEM
D
AILY
Base - May 2004
1. Replace the sensor on the gearbox with a suitable one for
tachograph.
2. Seal with lead the electrical connection to the sensor and
to the gearbox body.
If necessary, drill (4 mm) the ribbing on the gearbox (see
arrow) for passing the wire.
SENSOR REPLACEMENT ON GEARBOX
CONNECTION OF SENSOR TO WIRING
SENSOR TECHNICAL VIEW
Figure 344
8796
Figure 345
8797
Figure 346
8798
ELECTRIC/ELECTRONIC SYSTEM
289
D
AILY
Operation in bonnet
1. Disconnect the terminals of the power cables from the
battery terminals.
2. Remove the battery from the engine compartment, after
removing the fastening bracket.
3. Seal the connector between the frame and cab/bonnet
cables with sealing wire.
4. Refit the battery, re-connect the terminals to the battery
terminals, ensuring correct polarity and calibrate the
tachograph using the special VDO tool.
5. In the front part, seal the tachograph control unit with the
special red plug as shown.
6. Apply the labels; on the driver's door and on the tilting
plate of the tachograph control unit.
10.04.98
13 : 00
100436.8km
CONNECTOR BETWEEN CAB/BONNET AND FRAME
CABLES
FRONT VIEW OF TACHOGRAPH CONTROL UNIT
Figure 347
8799
Figure 348
8800
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст