Geely FC. Manual part — 99
Geely FC. Manual part - 99
Exterior/inner trim board--Inner trim board of top
29. Disassemble the pothook of sun shade [68010086]
Turn the pothook of sun shade to left for 90°, then disassemble
it.
30. Disassemble fixing pedestal of rear window sun
blind.
Use screw driver to turn the fixing pedestal of sun blind for 90°,
then disassemble it.
31. Disassemble trim tape of top sunroof [67010010]
32. Disassemble inner trim board of top [68010035]
(a) Use screw driver to disassemble inner trim board of top.
Hint: before using screw driver, its needled top should
be twisted by adhesive tape.
(b) Disassemble three fixing clamps and inner trim board of
top.
(c) Take out inner trim board of top from rear door.
33. Assemble inner trim board of top [68010035]
(a) Liking that shown in figure, align the mark, then fix the wir-
ing harness of top with adhesive tape.
(b) Use three fixing clamps to assemble inner trim board of top.
34. Assemble the pothook of sun shade [68010086]
Turn the pothook of sun shade to make fixing claw proturde,
then assemble sun shade.
35. Assemble rear row chair left backrest assembly
[68010078]
36. Assemble rear row chair right backrest assembly
[68010079]
37. Assemble rear row chair backrest assembly
[68010076]
Fixing
clamp
Adhesive
tape
393
Automobile control system--Ignition switch and anti-versa lock key warning switch
Phenomenon
Ignition switch could not insert on any
position
Possible malfunction part
1. Ignition switch
2. Circuit of power supply
Reference page
394
-
Automobile control system
Ignition switch and anti-versa lock key warning switch
Malfunction phenomenon table
Inspection
1. Check the ignition switch.
Check the conduction of ignition switch joint and terminal
If the conduction does not accord with the regulation, change
the switch.
2. Check the anti-versa lock key warning switch.
If the conduction does not accord with the regulation, change
the switch.
394
Position of switch
Terminal connected by avometer
Regulated situation
LOCK
-
Not conduction
ACC
1-3
Conduction
ON
1-2-3, 5-6
Conduction
START
1-2, 4-5-6
Conduction
Position of switch
Terminal connected by avometer
Regulated situation
OFF (key does not insert)
-
Not conduction
ON (key inserts)
1-2
Conduction
Ignition switch/starting/charging
Electrical schematic diagram--Ignition switch/starting/charging
395
Electric injection control of engine
Electrical schematic diagram--Electric injection control of engine
396
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст