Geely FC. Manual part — 43
Geely FC. Manual part - 43
Five gear
Check the axial clearance of third gear with clearance gauge,
its standard value is: 0.1—0.35 mm.
Check the axial clearance of fifth gear liking that shown in
figure, its standard value is: 0.1—0.50 mm.
Check the radial clearance of forth gear and fifth gear liking
that shown in figure, its standard value is less than 0,058mm.
Transmission—Disassemble assembly
169
Third gear
Third gear
Put input shaft assembly into position with pressure machine
liking that shown in figure, at the same time, hold the lower
end of input shaft to disassemble gear cover, gear hub and
five gear.
Check the axial clearance of forth gear, its standard value is:
0.1—0.55mm.
Take down clip spring used by shaft with clip spring wrench.
Take out fixing ball with magnetic stick, and take down the
gear and third-and-forth synchronous gear loop.
Transmission—Disassemble assembly
170
Take down clip spring with clip spring wrench.
Note: do not hurt its surface.
Take down synchronizer assembly, synchronous loop and third
gear with pressure machine liking that shown in figure.
Note: hold lower end of shaft with hand to make it stand.
Take down radial ball bearing with pressure machine, and
hold lower end of shaft with hand to make it stand.
Disassemble synchronizer assembly liking that shown in
figure.
Transmission—Disassemble assembly
171
Take our elastic cylindrical pin from shift swing lever with pin
taker and hand hammer liking that shown in figure.
Note: do not hurt its surface.
Take down clip spring liking that shown in figure.
Disassemble interlocking bracket, shift swing lever, spring and
A gasket liking that shown in figure.
Disassemble shift swing lever and connecting bolt.
Disassemble clip spring liking that shown in figure, and dis-
connect it.
Transmission—Disassemble assembly
172
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст