Geely CK (2008). Manual part — 88
Geely CK (2008). Manual part - 88
349
Take out the rear trunk carpet, spare tire cover board and the rear trunk miscelleaneous box. Screw the
spare tire press plate assembly to take out the spare tire.
2. Installation
1
Clip the rear trunk inside trim onto the corresponding hole in the reserve order of the removal;
2
Install the right rear and left rear combination lamp access hole cover;
3
Install the right and left speaker grill to the rear partition inside trim with a cross screwdriver;
4
Install the rear partition inside trim to the vehicle body;
5
Install the high mounted stop lamp and the C- pillar upper inside trim.
(XV) Engine Hood Inside Trim
Engine Hood Inside Trim Diagram:
Engine Hood Inside Trim
1. Engine Hood Inside Trim
2. E-Clip
1. Removal
1
Open the engine hood and gas spring;
2
Remove the clip and remove the engine hood inside trim
2. Installation
1
Open the installed engine hood and gas spring;
2
Align the corresponding hole position in the the engine hood inside trim and press the clip in by hand.
2
1
350
(XVI) Door
Front Door
Front Door Components:
1.Front Door
2.Front Door Hinge
3.Front Door Lock And Door Lock Actuator
4.Front Door Inner Trim Board 5.Power Window Motor
6.Power Window Actuator
7.Door Inside Handle
8.Protection Device
9.Door Outside Handle
10.Front Door Lock Hole
11.Front Door Glass
12.Door Window Regulator Run
13. Front Door Weatherstrip A
14.Front Door Lower Weatherstrip
15.Front Door Weatherstrip B
16.Front Door Lock Striker
11
16
10
8
9
3
15
14
13
4
5
6
1
12
2
7
351
1.Front Door Removal/Installation
(1) Disconnect the negative (--) terminal cable from the battery.
(2) Remove the front fender and remove the front door hinge.
(3) Remove the connector (See Notice on Removing the
Connector for detailed information)
(4) Remove front door hinges
(5) Remove the front door
(6) The installation is in the reverse order of the removal.
(7) Adjust the front door. (See Door Adjustment for detailed
information)
Front Door inner trim
1. Front Door Inner Trim Board Assembly
2.Front Door Inner Handle Assembly
3.Trim Board
4.Door Handle
5.Set Screw
1
2
4
3
5
2
Set Screw
352
1.The Front Door Inner Trim Board Removal/Installation
(1) Remove the set screw.
(2) Remove the front door inner trim board assembly.
(3) Disassemble the inner trim board assembly as required
(4) The installation is in the reverse order of the removal.
2.Front Door Glass Removal And Installation
(1) Lift the front door window glass, make the distance between
the front window glass top and rear door top weatherstrip
to be 130mm.
(2) Disconnect the negative (--) terminal cable from the battery.
(3) Remove the front door frame.
(4) Remove the hole cover.
(5) Remove the screw.
(6) Insert your hand into the front door component hole to lift
the front window glass.
(7) The installation is in the reverse order of the removal.
3.Glass Regulator Removal/Installation
(1) Loose the set screw: (See Figure)
Front
Door
Glass
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст