Geely CK (2008). Manual part — 41
Geely CK (2008). Manual part - 41
161
Chapter 2 Starting and Charging System
Section 1 Starting System
(MR479Q MR479QA MR481QA)
I. STARTER INSPECTION
NOTICE:
These tests must be done within 5 seconds to avoid burning out the coil.
1. INSPECT MAGNETIC SWITCH
(a) Use wire to connect the starter as shown.
(b) Connect the magnetic switch and the battery as
shown.
(c) Disconnect the magnet exciting coil from the
terminal A.
(d) Check if the clutch pinion gear is moving out.
If the clutch pinion gear is not moving out, replace
the magnetic switch.
(e) Connect the battery as shown above. Disconnect
the battery positive (+) from the terminal, to make the clutch pinion gear disengaged.
(f) Check if the clutch pinion gear has returned.
If the clutch pinion gear has not returned, replace
the magnetic switch.
Terminal A
Battery
Battery
Disconnect
162
2. INSPECT STARTER NO-LOAD
(a) Connect the magnet exciting coil and the terminal.
(b) Connect the ammeter and the battery to the starter
as shown.
(c) Check that the starter rotates smoothly and steadily
with the clutch pinion gear moving out.
(d) Check that the ammeter shows the specified
current.
Specified current: 90 A or less at 11.5 V
if the current is not normal, replace the starter.
3. WIRING
(a) Check that the connecting wire between
the positive (+) and the starter is stable
and reliable, and the insulating bush is in
good condition, in order to avoid a fire
caused by electric spark.
(b) Check that there is continuity in the wire
and if the insulating bush is not damaged.
If the harness is damaged, replace it.
Ammeter
Ignition Switch
Battery
Main Fuse Box
Starter
163
II. STARTER ASSEMBLY REPLACEMENT (MR479Q, MR479QA, MR481QA)
1. REMOVE STARTER ASSEMBLY
(a) Disconnect the starter connector.
(b) Remove the nut, and disconnect the starter
cable.
(c) Remove the 2 bolts and the starter
assembly.
2. INSTALL STARTER ASSEMBLY
Install according to the inverted order of removal.
Torque:
Bolt 37N.m (378kgf.cm, 27ft.lbf)
Harness 9.8N.m(100kgf.cm, 7.0ft.lbf)
164
Section 2 Charging System
(MR479Q, MR479QA, MR481QA)
I. BATTERY
Maintenance-free battery is applied in this vehicle. Its termination voltage is 12V. It is connected inline by six
2V single cell in tandem with walls between every pole.
1. BATTERY WARNING SIGNS
1 -- Danger of corrosion
The battery electrolyte is very corrosive. DO NOT overturn the battery.
2 -- Read the instructions for battery
3 -- Children are forbidden to touch the battery
4 -- Avoid fire, electromagnetic wave and strong light.
Avoid electric spark while repair; avoid short.
5 -- Wear protecting glasses
6 -- Danger of explosion
The explosive mixed gas will be produced while charging.
7 -- How to deal with a scrapped battery
The scrapped battery should be delivered to the collection station.
1
2
3
4
5
6
7
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст