Geely Emgrand X7. Manual part — 242
Geely Emgrand X7. Manual part - 242
2.13.8.2 Replacement of Cylinder Hood Cover
Warning: refer to "warning of battery disconnection" in "warnings and precautions".
Dismantlement Procedure
1. Disconnect the battery negative
electrode cable. Refer to 2.11.8.1
Battery Disconnection.
2. Refer to 2.13.8.1 "Replacement
of Plastic Shield of Engine" to
dismantle the engine shied.
3. Dismantle ignition coil and
ignition guide wire . refer
to“2 . 10 . 8 . 3 ignition coil
replacement ” .
4. Dismantle the crankcase
ventilation tube .
FE02-0009b
5. Dismantle the forced ventilation
vacuum pipe of the crankcase.
FE02-0010b
6. Dismantle cylinder hood cover
bolts and nuts.
FE02-0011b
967
7. Remove the cylinder hood cover.
FE02-0012b
8. Dismantle the cylinder hood
gasket from the cylinder hood
cover.
FE02-0013b
968
Installation Procedure:
1. Install the cylinder hood cover
gasket.
FE02-0014b
2. Apply sealant evenly in the
cylinder hood gasket.
3. Install the cylinder hood cover.
FE02-0015b
969
4. Tighten the cylinder hood cover
bolts.
Note: pay attention to single bolt
fastening more than once.
Fasten and tighten according to the
specified torque.
Short Bolts:
Torque: 9Nm (Metric) 6.66 lb-ft
(English system)
Long Bolts, Nuts, Special Bolts:
Torque :11N . m(Metric) 8 .
2lb-ft(English system)
FE02-0011b
5. Install the forced ventilation
vacuum pipe of the crankcase.
FE02-0017b
6. Install the crankcase ventilation
vacuum tube.
7. Install the ignition coil and
ignition wire.
8. Install the plastic shield of
engine.
9. Connect battery negative cable.
FE02-0018b
970
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст