Geely Emgrand X7. Manual part — 393
Geely Emgrand X7. Manual part - 393
6.4.5.7 Brake fluid level sensor replacement
Dismantle procedure
Warning!
Warning: Refer to warning for battery disconnection
in Warning and precaution .
1. Disconnect the battery negative cable. Refer to
2.11.8.1 Battery cable disconnection/connection
procedures.
2. Disconnect brake fluid level sensor harness
connector.
NL06-0030b
3. Take out brake fluid level sensor from the bottom
of brake fluid reservoir.
Notes:
It is unnecessary to discharge the brake fluid.
NL06-0049b
Installation Procedure:
1. Install brake fluid level sensor to fluid reservoir.
NL06-0050b
1571
2. Connect the harness connector of the brake fluid
level sensor.
3. Connect the battery negative cable.
NL06-0050b
1572
6.4.5.8 Replace brake pedal assembly
Dismantle procedure
1. Remove instrument panel. Refer to 12.8.3.1
Instrument Panel Replacement.
2. Separate vacuum booster connecting rod U clip
from brake pedal.
3. For dismantling of brake lamp switch, refer to
11.3.8.13 Replacement of brake lamp switch.
NL06-0044b
4. Dismantle fixing bolt on the upper of brake
pedal.
NL06-0045b
5. Remove the 4 fixing nuts at the bottom of the
braking padel.
6. Take out the brake pedal assembly.
NL06-0051b
1573
Installation Procedure:
1. install brake pedal
2. Install and tighten upper fixing bolt of brake
pedal.
Torque:21 Nm(Metric) 15.5 lb-ft(English system)
NL06-0051b
3. Install and tighten 4 fixing nuts on the lower
section of brake pedal.
Torque:21 Nm(Metric) 15.5 lb-ft(English system)
4. Install brake lamp switch.
NL06-0045b
5. Install the U-shaped clip of the vacuum booster
connecting rod and brake pedal connecting pin
and install the fixing pin.
6. Install the instrument panel.
NL06-0044b
1574
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст