Geely Emgrand X7. Manual part — 562
Geely Emgrand X7. Manual part - 562
11.5.8.15 Replacement of triangle glass
Dismantlement procedure
1. For dismantling of rear column
upper trimming plate, refer to
12.9.1.6 replacement of rear
column upper trimming plate
assembly.
Replace
2. Use fine steel wire to cut glass
sealing glue around the triangle
glass.
Notes:
Both ends of thin steel wire are wound
with wood blocks, which is operated
by two persons to facilitate
disassembling.
NL11-0074b
Installation procedure:
1. Open the dedicated Geely glass
sealant nozzle to make the edge
of glass sealant is with a width of
8 mm (0.3in) and a height of 8
mm (0.3in).
NL11-0069b
2. With a double-pipe gun evenly
apply glass sealant to the edge of
window glass to make sure that
the width of sealant is even.
3. Use sucker to install triangle
glass into triangle glass window
frame of vehicle body.
4. Press triangle glass, and then
apply adhesive tape on triangle
glass and triangle glass window
frame to fix triangle glass.
5. Let the glue dry for 24h.
6. Spray water to the triangle
window to check for leakage. If
leaking water, dry triangular
glass and plug the leakage part
NL11-0070b
2247
through glazing compound. If
still leaking water, dismantle the
triangular glass and repeatedly
execute the whole maintenance
procedure.
7. Install the rear column upper trim
panel.
2248
11.6 Wiper /washing system
11.6.1 Specification
11.6.1.1 Fastener specifications
Torque range
Fastener name
Model
Metric (N.m)
Inch (lb-t)
Front fender liner screw
ST4.8×19
4-6
3-4.4
Fixing bolt of washer fluid
reservoir
M6×20 7-9 5-6
Fixing support of wiper
M6×16
9-12
6-8.9
wiper motor bolt
M6×25
8-11
6-8
Connecting rod nut of wiper arm
M8
14-16
10-12
Wiper arm nut
M8
14-16
10-12
Rear wiper motor bolt
M6×25a
8—11
6—8
Rear wiper nut
M6
8—11
6—8
2249
11.6.2 Description and operation
11.6.2.1 Description and operation
Wipers / washers system consists of the following components:
– Central
controller
– Wiper/washer
switch
–
IF30 20A front washer fuse
–
Washer fluid reservoir
–
Front wiper motor
– Washer
fluid
pump
–
Front wiper arm and connecting rod device
– Washer
nozzle
–
Rear wiper motor
–
Rear wiper fluid pump
–
Rear wiper relay
–
IF23 15A rear wiper fuse
–
Rear wiper arm
The wiper/washer for the standard/comfort version can operate in the High Speed, Low Speed and
Clearance modes and can be automatically return the original position when the wiper switch is
turned off. The wiper switch is arranged on the control level at the right side of the steering
column.
Front wiper/washer system
The front wiper system consists of a wiper/washer switch, a wiper motor, a connecting rod, a
wiper arm and a wiper blade. The front wiper circuit is provided with a self-stop device which
consists of a worm gear and a cam plate, with the purpose of further transiently keeping the circuit
complete after disconnecting the wiper/washing switch; and the circuit is disconnected until the
wiper arm completely returns to the initial position. Wiper system is driven by a permanent
magnet motor. The front wiper motor is installed on the front fender and directly connected with
the front wiper connecting rod. Wiper switch is a component of wiper / washer system.
Front windshield washer system
The front windshield washer system consists of a glass cleaning agent, a fluid reservoir, a washing
fluid pump, a hose, a nozzle and a wiper/washing switch. The front windshield washing fluid
reservoir is installed below the right front headlamp assembly and at the front of the right front
fender liner. The washing fluid pump is fixed on the washer fluid reservoir and transmits the
washing fluid to the two nozzles through the hose. Washer switch is also a component of
wiper/washer switch.
Rear wiper/washer system
The rear wiper/washer system consists of wiper motor, wiper arm and wiper blade. Rear window
wiper motor is located in the back door, is directly connected with the rear window wiper arm and
equipped with independent washing fluid pump, hose and nozzle. The rear window washer and the
front window washer share one washing fluid storage tank. The washing fluid pump transmits the
washing fluid to the rear wiper nozzle through the hose and then uniformly sprayed on the rear
windscreen through the nozzle.
2250
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст